Hisun HS400 Service Manual page 43

7. Apply a protective substance to the
plastic and rubber components.
Make sure to follow the
manufacturer's instructions for each
type of product being used.
8. Place the UTV on a work stands
with all wheels off the ground.
9. Cover the UTV with old bed sheets
or something similar. Do not cover it
with any plastic material that will
trap moisture.
Returning the UTV to Service
The amount of service required when
returning a UTV to service after storage
depends on the
length of non-use and storage conditions.
In addition to performing the reverse of the
storage procedure, note the following:
1. Remove the covers from the intake
and exhaust openings.
2. Service the air filter
3. Inspect the cooling system. Check
the drain plug and hose
connections for leaks.
4. Refill the fuel tank. Turn the fuel
shutoff valve on and check for fuel
leaks.
General
5. Make sure the brakes, clutch,
throttle and engine stop switch work
properly before operating the UTV.
Evaluate the service intervals to
determine which areas require
service.
6. If the UTV has been in storage for
longer than four months, change
the engine oil as and filter, and the
transmission oil as described.
1-37