Specifications; Operation; Charging The Battery Pack - Ryobi BCS618 Operator's Instruction Manual

SPECIFICATIONS

Compatible Voltage
Battery
Pack
130109033 18 V
ABP-1815
ABP1801
BPL-1815
BPL-1820
RB18L13
RB18L15
RB18L26
RB18L40

OPERATION

WARNING
Do not allow familiarity with products to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating products.
Failure to do so could result in objects being
thrown into your eyes, resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
We recommend that the tool be always
supplied via a residual current device with a
rated residual current of 30 mA or less.
APPLICATIONS
You may use this product for the following purposes:
 Charging and maintaining Ryobi One+ 18V battery
packs at peak charge every time (not over time).
CAUTION:
Charge in a well-ventilated area. Do not block
charger vents. Keep them clear to allow proper
English
Charger Chemistry
Input
220-240V, 50-60Hz, Ni-cd
AC only
Li-ion
Battery
Capacity
1.5 Ah
1.7 Ah
1.4 Ah
2.4 Ah
1.3 Ah
1.5 Ah
2.6 Ah
4.0 Ah
ventilation.
CAUTION:
If at any point during the charging process, none
of the LEDs are lit, remove the battery pack from
the charger to avoid damaging the product. DO
NOT insert another battery. Return the charger
and battery to your nearest service center for
service or replacement.
BATTERY PROTECTION FEATURES
Ryobi One+ 18 V Lithium-Ion batteries are designed with
features that protect the Lithium-Ion cells and maximise
battery life.
If the tool stops during use, release the trigger to reset
and resume operation. If the tool still does not work, the
battery needs to be recharged.
NOTE: The LED charge indicator light will not work if the
battery protection feature has caused the battery pack
to stop powering the tool. When the battery pack resets
itself, the LED will again function.

CHARGING THE BATTERY PACK

Use only Ryobi One+ 18V battery packs with
this charger.
Battery packs for this tool are shipped in a low charge
condition to prevent possible problems. Therefore,
you should charge them until the green LED on the front
of the charger comes on.
Note: The charger will also charge Ryobi One+ 18 V
Ni-Cd battery packs.
2
No. of cell for
battery
15
5
10
5
5
10
10