Installation Instructions Renaissance Range ® For use with models ER36D, ER36D-C, ER48D, ER48D-C THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES. Part No. 100843 Rev. Z...
Use common sense and caution when installing, maintaining or operating this or any other appliance. WARNING Always contact the Dacor Customer Service Team about problems NEVER cover any slots, holes or passages on the inside or and conditions that you do not understand.
Important Safety Instructions General Safety Precautions To reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual before operating this appliance. •...
Customer Service Information Model Identification If you have questions or problems with installation, contact your Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty call the Dacor Distinctive ER36D-C-SCH/NG/H Service line. Whenever you call, have the model and serial number of the appliance ready.
Refer Have a minimum rating of 250 Volts @ 30 Amps for to the range rating label and the table on page 3 to model ER36D, 250 Volts @ 50 amps for model ER48D determine the correct model. ◊...
• Access to the remote circuit breaker panel/fuse box, when the • The range may be installed flush to the rear wall. Dacor range is in place. strongly recommends installing a non-combustible material • The gas supply piping and shut-off valve, and the electrical...
1 Standard size rack (PN 82107/82106) (PN 62783) See the use and care manual for a list of optional accessories. Center grate on ER36D: PN 700038 Small stack burner kit: PN 100699 Large stack burner kit: PN 700493 Crown burner kit: PN 100703...
• Improper connection of the electrical wiring can cause an release causing personal injury. electric shock hazard and damage the appliance. Dacor • Do not lift or carry the oven door(s) by the handle. is not responsible for damages resulting from improper installation.
Page 11
Installation Instructions Refer to the range rating label (see page 3) for power requirements. L1 terminal There are four possible ways to wire the range: Neutral terminal • 4 wire conduit L2 terminal • 3 wire conduit (where local codes permit) •...
Page 12
Installation Instructions Electrical Connection (cont.) Connection to Connecting the Conduit to the House power supply Electrical Junction Box WARNING Junction box Do not connect the green appliance wire to the neutral (white) supply wire unless local building codes permit. Wire nut NOTES: WHITE 4 places...
Page 13
Installation Instructions Separate No. 10 (minimum) Connection to copper grounding wire power supply Junction box Fasten clamp tightly on pipe Wire nut 4 places Connection to appliance (Page 9) 4 Wire Conduit Connection to Junction Box with External Ground No. 4 Meter copper wire Metal...
Page 14
Installation Instructions Electrical Connection (cont.) Slide the end of the appliance cord into the strain relief from the bottom of the box. Connecting an Appliance Cord to the Connect the white (neutral) wire to the neutral terminal in the box. Range - Where Local Code Permits Connect the L1 wire to the L1 power supply terminal in the box.
Installation Instructions Gas Connection WARNING • Make sure the gas supply valve is off and that the power to Bare wire the range is turned off at the circuit breaker or fuse box prior connections to connecting the gas line. •...
Installation Instructions Final Installation Re-installing the Oven Door(s) Peel the protective coating off of the range, including the WARNING door. To avoid personal injury or damage to the door from it falling off Measure from the floor to the countertop. Adjust the leveling its hinges: legs as required to position the trim around the cooktop even with or above the countertop.
Installation Instructions Installing the Burner Knobs Put the knobs with the words “MAX GRIDDLE” on them onto the inner (center burner) valve shafts. WARNING Installing the range knobs in the wrong position may result in damage to the griddle included with the range. The knobs for the center burners are marked with the maximum griddle settings.
• Gently set the grates on top of the spill tray. Put the legs of each grate inside the corresponding dimples. On model ER36D, the largest grate goes in the center. Ridge on bottom of burner cap STEP 3: Install burner cap.
Repeat the above bake test or burner ignition test. If the appliance still does not work, contact Dacor Distinctive Service at (800) 793-0093 ex. 2822. Do not attempt to repair the appliance yourself. Have the model and serial numbers available when you call.
Page 20
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com...
Need help?
Do you have a question about the ER36d and is the answer not in the manual?
Questions and answers