Step 3: Preparing A Power Supply - Sony HVR-S270E Operating Manual

Step 3: Preparing a power supply

The following power supplies are
recommended for your camcorder.
• BP-GL65/GL95/L60S/L80S Lithium-ion
Battery Pack
• AC power using the AC-550, AC-DN2,
AC-DN10 AC Adaptor
Using a battery pack
Approximate operating time (min.) when
you use a fully charged battery pack.
Model name HDV
BP-GL65 240
BP-GL95 370
BP-L60S 215
BP-L80S 295
Before use, charge the battery pack with a
charger suitable for each battery.
• All times are measured under following
conditions.
– when recording on both tape and Memory
Recording Unit (HVR-MRC1)
– when using the microphone (ECM-XM1)
– when recording continuously
– when using the viewfinder with the LCD
panel closed
• For details on charging procedure, refer to the
battery charger operation manual.
b Notes
• A warm battery pack may not be able to be fully
recharged.
• When you set [BATTERY TYPE] appropriately
for your battery, approximate remaining battery
capacity is displayed on the screen. The
displayed approximate remaining battery
capacity may slightly differ from that indicated
by the indicator on your battery (p. 91).
To attach the battery pack
1 Press the battery pack against the back
of the camcorder, aligning the line on
the side of the battery pack with the
matching line on the camcorder.
16
DVCAM (DV)
255
385
230
310
Back of the camcorder
2 Slide the battery pack down until its
"LOCK" arrow points at the matching
line on the camcorder.
To detach the battery pack
b Notes
• During recording, playback, and loading/
unloading a tape, be careful never to remove the
battery pack.
• Make sure to turn the camcorder off before
changing the battery (except when using an AC-
550 and an AC-DN2/DN10 AC Adaptor
together).
Battery pack
Align these lines.
"LOCK" arrow
Line on the
camcorder
Holding the
button in, pull
the battery pack
up.