Page 1
Easy-Stat Wireless Programmable Room Thermostat Pt No 7.2000050...
Page 2
Transmit button Installing the programmable room thermostat The Alpha Easy-Stat is a programmable room thermostat and must be installed in the correct position, approximately 1.5 meters from the ground and must not be fitted in any of the following positions;...
Page 3
Fig 2. Rotary Knob Transmit Button Temperature Button Offer the back plate in suitable location making sure it is level and a 100mm gap is maintained on the left side then mark the screw positions on the wall. Using a 5mm drill bit drill the holes in the wall and insert the wall plugs.
Page 5
Commissioning Procedure The controller is supplied pre-commissioned (paired to the receiver). Should the timer need to be paired to a new receiver then the following procedure must be followed. Press the transmit button on the receiver for 5 seconds and the light will flash. Press the transmit button on the timer for 5 seconds and the timer will pair with the receiver, indicated when the receiver light stops flashing.
Page 6
Turn the knob and 6 and 7 will be underlined (Saturday and Sunday), press the knob to enter the heating on/off time periods. The display will show a graph at the top representing each hour of the day and the time from midnight, turn the knob to scroll through the hours of the day and press the transmit button to select an on period, this will be identified by a solid block in the graph for each hour selected.
Page 7
Heating on This setting controls the temperature at which the heating is switched back on after the set temperature is reached e.g. if the temperature is set to 20⁰C the heating will be held off until the room temperature falls by the amount set . For example; a 0.5⁰C setting means that the heating will switch on when the temperature falls to 19.5⁰C.
Need help?
Do you have a question about the Easy-Stat 7.2000050 and is the answer not in the manual?
Questions and answers