Wiring - Honeywell RTH7600 Series Installation Instructions Manual
Touchscreen programmable thermostat
Hide thumbs
Also See for RTH7600 Series:
- Quick installation manual (61 pages) ,
- Operating manual (52 pages) ,
- Quick start manual (2 pages)
Advertisement
Available languages
Available languages
Wiring—heat pump
Alternate wiring (for heat pumps only)
Leave metal jumper in place, connecting R & Rc
terminals.
If your old thermostat had both V and VR wires,
stop now and contact a qualified contractor for
help.
If your old thermostat had separate O and B
wires, attach the B wire to the C terminal. If
another wire is attached to the C terminal, stop
now and contact a qualified contractor for help.
If your old thermostat had Y1, W1 and W2 wires,
stop now and contact a qualified contractor for
help.
If L terminal is used, C terminal wire must be
5
connected (contact a contractor if there is no C
wire).
If E and Aux terminals do not each have a wire
connected, use a small piece of wire to connect
6
them to each other.
3
4
2
3
5
5
6
6
23
69-2206ES—05
RTH7600
M28077
Hide quick links:
Advertisement
Chapters
Troubleshooting
Need help?
Do you have a question about the RTH7600 Series and is the answer not in the manual?
Questions and answers
I had the “ low battery” display (system still running), changed battery and now system completely dead. Is this common for this model (rth7600d)??
The manual does not explicitly mention the thermostat becoming completely unresponsive after changing the battery. However, if the thermostat does not function after a battery change, troubleshooting steps such as ensuring proper battery installation, checking for secure connections, or performing a reset may help resolve the issue.
This answer is automatically generated