Hex Wrench Storage - Makita DHS680 Instruction Manual

2
3
015108
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
hex bolt clockwise. Then remove the hex bolt, outer
flange and blade.
1
2
015109
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
COUNTERCLOCKWISE SECURELY.
When changing blade, make sure to also clean the
upper and lower blade guards of accumulated sawdust
as discussed in the Maintenance section. Such efforts
do not replace the need to check lower guard operation
before each use.
For tool with the inner flange for other than 15.88
mm hole-diameter saw blade
CAUTION:
Make sure that the protrusion "a" on the inner
•
flange that is positioned outside fits into the
saw blade hole "a" perfectly. Mounting the blade
on the wrong side can result in the dangerous
vibration.
1 2
3
011230
The inner flange has a certain diameter protrusion on
one side of it and a different diameter protrusion on the
other side. Choose a correct side on which protrusion
fits into the saw blade hole perfectly.
1. Hex wrench
2. Shaft lock
3. Tighten
4. Loosen
4
1
1. Inner flange
2. Saw blade
3. Outer flange
4. Hex bolt
3
4
1. Mounting shaft
5
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
4
Next, mount the inner flange onto the mounting shaft so that
the correct side of protrusion on the inner flange faces
outward and then place saw blade and outer flange.
BE SURE TO
COUNTERCLOCKWISE SECURELY.
For tool with the inner flange for a 15.88 mm hole-
diameter saw blade (country specific )
1 2
011231
1 2
15.88
014598
Mount the inner flange with its recessed side facing outward
onto the mounting shaft and then place saw blade (with the
ring attached if needed), outer flange and hex bolt.
BE SURE TO
COUNTERCLOCKWISE SECURELY.
WARNING:
Before mounting the blade onto the spindle,
•
always be sure that the correct ring for the blade's
arbor hole you intend to use is installed between
the inner and the outer flanges. Use of the incorrect
arbor hole ring may result in the improper mounting of
the blade causing blade movement and severe
vibration resulting in possible loss of control during
operation and in serious personal injury.

Hex wrench storage

1
015110
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
11
TIGHTEN THE HEX
1. Mounting shaft
5
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
4
3
1. Mounting shaft
5
6
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
6. Ring
4
3
TIGHTEN THE HEX
1. Hex wrench
BOLT
BOLT