Makita 1050D Instruction Manual page 7

2
1. Pan head screws
2. Installation bolts
1. Hex wrench
2
1
1. Dust bag
2. Nozzle
3. Fastener
1
2
1. Thumb screw (A)
2. Washer
3. Edge fence
4. Thumb screw (B)
Blade height adjustment
002567
Blade height adjustment is usually not necessary. However, if you notice that
1
the blade edge is below the level of the rear base or protrudes too far from the
rear base, proceed as follows.
Loosen the two installation bolts. Turn the pan head screws clockwise to
retract the blade or counterclockwise to protrude it. After adjusting the blade
height, tighten the two installation bolts securely.
Hex wrench storage
002568
When not in use, store the hex wrench as shown in the figure to keep it from
being lost.
1
Dust bag
002572
Install the dust bag on the nozzle of the tool. When installing it, push the bag's
entry port toward the nozzle as far as it will go to prevent it from coming off
during operation.
For the best results, empty the dust bag when it becomes about half full.
Remove the dust bag from the tool and pull out the fastener.
NOTE:
3
• If you connect a Makita vacuum cleaner to this tool, more efficient and
cleaner operations can be performed.
Edge fence (Guide rule)
002573
Use the edge fence when shiplapping (rabbeting) or cutting workpieces nearly
50 mm wide. Install the edge fence on the tool and secure it with the washer
and thumb screw (A). Loosen the thumb screw (B) and adjust the edge fence
until it comes in contact with the side of the workpiece. Then tighten the thumb
screw (B) securely.
3
4
7