Table of Contents
Advertisement
WebWay IP/GPRS & WebWay GPRS/PSTN Installation Manual
WebWayOne
WebWay IP/GPRS & WebWay GPRS/PSTN
Installation Manual
Alarm signalling & remote alarm system management
For high security signalling with EN50131-1 Grade 2, 3 & 4 I&HAS
WebWay IP/GPRS LPS I&HAS – LPCB 1022b/01
I&HAS Grade 2 – Dual Path LPS 1277 ATS5
I&HAS Grade 3 – Dual Path LPS 1277 ATS5
I&HAS Grade 4 – Dual Path LPS 1277 ATS5
Sweden + Europe SSF 114 Version 2 (alarm classes 1, 2, 3, & 4)
Norway FNH, Denmark, Finland
Belgium/Netherlands INCERT T014 + A1:2020 + A2:2003 + A3:2005
EEC EN Grade 2, 3, & 4
WebWay GPRS/PSTN LPS I&HAS – LPCB 1022b/02
I&HAS Grade 2 – Dual Path LPS 1277 ATS4PLUS
I&HAS Grade 3 – Dual Path LPS 1277 ATS4PLUS
Sweden + Europe SSF 114 Version 2 (alarm classes 1, 2 & 3)
Norway FNH, Denmark, Finland
Belgium/Netherlands INCERT T014 + A1:2020 + A2:2003 + A3:2005
EEC EN Grade 2, 3, & 4
For high security signalling with EN54-21: 2006 Fire Alarm Systems
WebWay IP/GPRS LPS Fire – LPCB 1022a/01
Fire Alarms & Fault Warning Type 1 - Dual Path LPS 1277 Fire Type 1
WebWay GPRS/PSTN LPS Fire – LPCB 1022a/02
Fire Alarms & Fault Warning Type 2 - Dual Path LPS 1277 Fire Type 2
Important – For marking and labelling requirements please refer to pages 5 and 6 of this guide.
Part number 12-0031
Issue 2D July 2 2012
WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ
Tel 01635 231514: Email
support@webwayone.co.uk
Page 1
Advertisement
Table of Contents
Summary of Contents for WebWayOne WebWay IP/GPRS
-
Page 1: Installation Manual
Important – For marking and labelling requirements please refer to pages 5 and 6 of this guide. Part number 12-0031 Issue 2D July 2 2012 WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ Tel 01635 231514: Email support@webwayone.co.uk Page 1... -
Page 2: Table Of Contents
Annex B – LPS Installation procedures Code of Practice Page 18 Annex C – EC declaration of Conformity Page 20 Annex D – LPS 1277 conformance statement Page 22 WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ Tel 01635 231514: Email support@webwayone.co.uk Page 2... -
Page 3: System Description
System description WebWay IP/GPRS WebWay IP/GPRS is a dual path alarm signalling system for delivering alarms over a fixed line Broadband network and a Radio GPRS network. The WebWay managed service provides continuous surveillance of all transmission paths and equipment every second of every day. -
Page 4: Equipment Part Numbers
Cooper TS range alarm panel cable 05-0246 Texecom TTL alarm panel cable 05-5031 Castle serial alarm panel cable 22-1087 Grade 3 boxed PSU (battery not included) WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ Tel 01635 231514: Email support@webwayone.co.uk Page 4... -
Page 5: Webway Pre-Installation Notes
Enhanced configuration profiles are available for Intruder and Hold-up systems when using the WebWay IP/GPRS. These should be selected at the time of ordering the system and they will be configured into the WebWay IP/GPRS when it is commissioned to your selected ARC: When installed as a WebWay IP/GPRS I&HAS Signalling System the LPCB label will be identified by a tick in the 1022b/01 box... - Page 6 Important: When installed as a FIRE Signalling System a tick in the 22-5015 LPS Fire and 1022a/02 boxes denotes the approved hardware and configuration will identify the CE label. Important: The WebWay IP/GPRS should either be installed in the associated EN54 compliant Fire Alarm Panel or an EN54-4 compliant PSU.
-
Page 7: Webway Installation - Equipment Familiarisation
1A 1B 2A 2B PIN OUTPUT 3 ETHERNET BIAS VOLTAGES POWER PINS 1-8 END OF LINE PINS 9-16 PIN OUTPUT 2 PIN OUTPUT 1 WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ Tel 01635 231514: Email support@webwayone.co.uk Page 7... -
Page 8: Interfaces
Flashing Red – Not Commissioned Green on – 10BaseT Green off – 100BaseT Ethernet data Red - Data activity to and from the LAN WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ Tel 01635 231514: Email support@webwayone.co.uk Page 8... -
Page 9: Pins, Power
Reference voltages A+ Nominal 12 volts or 24 volts depending on application; A- 0 volts Power Inputs + PWR - adjacent to the Ethernet connector WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ Tel 01635 231514: Email support@webwayone.co.uk Page 9... -
Page 10: Installation Process
Default Gateway are required. To assist the client to configure the Firewall the following information is provided: The WebWay IP/GPRS is installed at the remote premises and communicates, via the customer network/firewall, with Monitoring Centre Transceivers (MCTs), located in the alarm-receiving centre (ARC). -
Page 11: Alarm Panel Connection - Serial
Connect the WebWay using the appropriate serial connection to the alarm panel and configure the panel according to the instructions detailed in the WebWay document. Please visit http://www.webwayone.co.uk/download/webway-manuals/Default.htm for the most update installation guides for all major panel manufacturers. The serial connections are 3 wires, which includes a return path ground from the Alarm Panel serial interface. - Page 12 Alarm panel connection – Modem Capture The Modem capture module may be used for Intruder & Hold up alarm signalling, Upload/Download and remote servicing. . Please visit http://www.webwayone.co.uk/download/webway-manuals/Default.htm for the most update installation guides for all major panel manufacturers. Modem capture module IMPORTANT NOTE: 1 When using the Modem capture in association with a fire system Fire Alarm, Fire Fault or Trouble messages must be transmitted using the PIN interfaces.
-
Page 13: Pin Inputs - Tamper, Battery Fail, Mains Fail
1 Failure to receive an acknowledgement to a Fire Alarm Message within 100s PIN output 3 Fault Warning 2 Failure of the WebWay IP/GPRS or WebWay GPRS/PSTN or power. 3 Failure of the Alarm Transmission Network (all paths failed) 4 A PIN fault (Open Circuit, Short Circuit etc.) EN50131 I&HAS mode 1... -
Page 14: Testing Alarm Signals With The Arc
When the WebWay AUTO TAKEON is completed you should send test alarms to your ARC. If the ARC successfully receives the alarms the system is fully commissioned. If the ARC does not receive the correct test alarms contact WebWayOne Technical Support on 01635 231514. Alarm Transmission Path tests with the ARC - Manual... -
Page 15: Remote Servicing Of Alarm Panels & Webway Ats Equipment
Remote servicing of Alarm Panels and the Alarm Transmission System is described in the new Standard DD263:2010 The WebWay IP/GPRS and the WebWay GPRS/PSTN are connected to the secure premises via the WebWay MCTs at the ARC. WebWay Remote Manager provides secure access software, permitting an Alarm System management package to remotely access an Alarm System and the WebWay from a secure premise using a secure computer. -
Page 16: Annex A - Configuration Profiles
90 seconds when the primary path is failed and the system will detect a catastrophic ATS failure or attack within 3 minutes. A unique feature of the WebWay IP/GPRS is the system software that provides availability figures for the monitoring and management every path of every ATS to 99.8%. -
Page 17: Ats Configurations Including Lps 1277 Ats4Plus And Ats5
Including: FIRE - LPS EN54-21 Type 1 & LPS EN54-21 Type 2 The revised table 11 is shown below and outlines the key parameters for the advanced performance of the selected signalling system. Highlighted performance criteria illustrate the WebWayOne advanced signalling solutions certificated by the LPCB. ATS 1... -
Page 18: Annex B - Lps Installation Procedures Code Of Practice
(not the factory default) and, if their equipment has wireless connectivity having the wireless network Access Point Name (APN) hidden. WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ Tel 01635 231514: Email support@webwayone.co.uk... - Page 19 WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ Tel 01635 231514: Email support@webwayone.co.uk...
-
Page 20: Annex C - Ec Declaration Of Conformity
Equipment WebWay IP/GPRS, WebWay GPRS/PSTN Model number 22- 5072 (WebWay IP/GPRS), 22- 5085 (WebWay GPRS/PSTN) Is in conformity with the applicable requirements of the following documents Alarm Transmission Systems, applications and safety standards EN50136-1-1: 1998+A2:2008 General requirements for alarm transmission systems... - Page 21 WebWay IP/GPRS LPS Fire Type 1 Technical data: see Doc. 12-0031 held by Technical data: see Doc. 12-0031 held by WebWayOne Ltd WebWayOne Ltd WebWayOne Ltd, 11 Kingfisher Court, Newbury, Berkshire, RG14 5SJ Tel 01635 231514: Email support@webwayone.co.uk Page 21...
-
Page 22: Annex D - Lps 1277 Conformance Statement
Where the WebWayOne SPT is installed in a separate enclosure to the fire alarm system and using a serial interface for the transmission of the fire alarm and fire fault conditions, then the interface must operate in compliance with the requirements of EN54-21 clause 5.3b4. - Page 23 The information in this section defines the statutory requirements for the equipment, installation system design and support services. The WebWayOne Alarm Transmission System is compliant with the relevant clauses of the following alarm transmission systems, alarm transmission equipment, emissions, and immunity standards.
Need help?
Do you have a question about the WebWay IP/GPRS and is the answer not in the manual?
Questions and answers
. When installing GPRS alarm transmission devices, which location is unlikely to be successful?
The least effective location for installing WebWayOne IP/GPRS alarm transmission devices is a position with the lowest GPRS signal strength, represented by '1' on the display. Additionally, the T-Bar Antenna should not be fixed to the enclosure, as stated in the installation instructions.
This answer is automatically generated