Installing The Upper Handle - Toro 1500 Power Curve 38371 Operator's Manual

119-9825
1. Warning—read the
Operator's Manual.
2. Thrown object
hazard—keep bystanders
a safe distance from the
machine.
3. Cutting/dismemberment
hazard of hand, impeller;
cutting/entanglement
hazard of foot,
auger—stay away from
moving parts; keep all
guards and shields
in place; disconnect
the machine from the
power outlet and read
the instructions before
servicing or performing
maintenance.
119-9841
1. 1) Push the interlock
switch; 2) Hold the handle
to engage the rotation of
the auger blade.
4. Cutting/dismemberment
hazard of hand, impeller;
cutting/dismemberment
hazard of foot,
auger—stop the engine
and the augur blade before
leaving the machine.
5. Electric shock hazard—do
not use a damaged power
cord.
2. Release the handle to
disengage the rotation of
the auger blade.
Setup
Note: Determine the left and right sides of the appliance from
the normal operating position.

Installing the Upper Handle

1. Remove the handle knobs, oval bolts, and curved washers
from the lower handle.
2. Install the upper handle to the lower handle of the appliance
with the handle knobs, curved washers, and oval bolts as
shown in Figure 1.
1. Handle knob (2)
2. Curved washer (2)
3. Oval bolt (2)
Note: Ensure that the power cord attached to the appliance
is routed over the lower handle and to the inside of the
handle assembly.
3. Tighten the handle knobs firmly by hand.
4. Attach the cord guide to the handle (Figure 2).
3
Figure 1
4. Lower handle
5. Upper handle