Loading The Paper Tray - Toshiba e-STUDIO203S Service Manual

8. Loading the paper tray

Note: Make sure that the paper is not torn, is free of dust, and has
no wrinkles or curled edges.
1) Raise the handle of the paper tray and pull the paper tray out
until it stops.
2) Remove the pressure plate lock. Rotate the pressure plate lock
in the direction of the arrow to remove it while pressing down on
the pressure plate of the paper tray.
3) Store the pressure plate lock which has been removed in step
2. To store the pressure plate lock, rotate the lock to secure it as
shown below.
Pressure plate lock
4) Squeeze the lock lever of the front guide and slide the paper
guide (A) to match the width of the paper, and move the paper
guide (B) to the appropriate slot as marked on the tray.
Paper guide (B)
• The front guide is a slide-type guide. Grasp the locking knob
on the guide and slide the guide to the indicator line of the
paper to be loaded.
• The left guide is an insert-type guide. Remove it and then
insert it at the indicator line of the paper to be loaded.
Paper guide (A)
e-STUDIO203S/203SD UNPACKING AND INSTALLATION 5 - 4
5) Fan the paper and insert it into the tray. Make sure that the
edges go under the corner hooks.
Note:
• Do not load paper above the maximum height line (
Exceeding the line will cause a paper misfeed.
• If the paper is not fanned, double-feeds or misfeeds may occur.
• Make sure the stack of paper is straight before loading it. When
adding paper, take the remaining paper out and combine it into a
single stack with the new paper.
• Make sure that all the paper in the stack is the same size and
type.
• When loading paper, ensure that there is no space between the
paper and the guide, and make sure that the guide is not set too
narrow and causes the paper to bend. Incorrect loading will
cause the paper to skew or misfeed.
6) Gently push the paper tray back into the machine.
Note:
• If you loaded a different size of paper than was loaded previously
in the tray.
• When not using the machine for an extended period, remove all
paper from the paper tray and store it in a dry place. If paper is
left in the machine for an extended period, the paper will absorb
moisture from the air, resulting in paper jams.
9. Power to copier
1) Ensure that the power switch of the copier is in the OFF posi-
tion.
Insert the attached power cord into the power cord socket at the
rear of the copier.
2) Plug the other end of the power cord into the nearest outlet.
3) The document stopper may fall down by vibrations during transit
of the product. If documents are set under such a state, the
JAM display may be indicated.
If the JAM display is indicated, remove the documents, turn
OFF/ON the power SW, complete initializing of the RADF, then
set the documents again.
).