Replacing The Fuse - Yamaha Aerox R NS50F Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
is turned to "
the positive lead before con-
necting the negative lead.
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals
and that the breather hose is
properly routed, in good condi-
tion, and not obstructed. NOTICE:
If the breather hose is posi-
tioned in such a way that the
frame is exposed to electrolyte
or gas expelled from the bat-
tery, the frame could suffer
structural and external damag-
6
es.
[ECA10602]
NOTICE
 Always
keep
charged. Storing a discharged
battery can cause permanent
battery damage.
 After installing the battery, be
sure to turn the main switch
from " " to "
3 seconds intervals to initialize
the idle speed control system.
", then connect

Replacing the fuse

[ECA17721]
ZAUM1079
1. Fuse
2. Battery
The fuse holder is located beside the
battery. Remove panel A to access the
fuse. (See page 6-6.)
ECAM1120
If the fuse is blown, replace it as fol-
lows.
the battery
1. Turn the key to "
electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
" three times in
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
EAUM3270
2
1
3. Turn the key to "
4. If the fuse immediately blows
" and turn off all
NOTICE:
[EWA15132]
6-25
After removing and installing
the main fuse, be sure to turn
the main switch
to " " three times in 3 seconds
intervals to initialize the idle
speed control system.
Specified fuse:
15.0 A
" and turn on
the electrical circuits to check if
the devices operate.
again, have a Yamaha dealer
check the electrical system.
from " "
[ECAM1130]