Table of Contents
Advertisement
7.
Connect the USB flash disk to your Eee PC.
Start the system and press <F2> on bootup to enter the BIOS
8.
setup. Go to Boot > Hard Disk Drives and select the USB drive
(may be labeled as "USB:XXXX") as the 1st Drive.
Go to Boot > Boot Device Priority and select the USB drive (may
9.
be labeled as "USB:XXXX") as the 1st Boot Device.
10 Press <F10> to save the configuration and reboot from the USB
flash disk.
11. Key in yes and press <Enter> to continue the system recovery.
12 When the recovery is completed, remove the USB flash disk and
press <Enter> to reboot the system.
Reformatting the USB flash disk
To use the USB disk on your Windows operating system normally,
follow the instructions below to reformat your USB disk.
1.
Connect your USB flash disk to another PC/NB and insert the
Support DVD to that PC/NB at the same time.
2.
Click Utilities on the left and select ASUS Linux USB Flash
Utility.
Select Format the USB flash
3.
disk back to Windows format
(FAT16) and click Run.
4.
Click OK to complete the disk
formatting.
ASUS Eee PC
6-11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Eee PC 4G (701) and is the answer not in the manual?
Questions and answers
unable to get on the internet. everything i try does not work. i **** being blocked for some reason. model 701 laptop. has windowes 7 starter. is my computer opsolete or can we up grade it to windows 10
unable to get on the internet. everything i try does not work. I **** being blocked for some reason. laptop is a model 701. has windows 7 starter on it. is my computer obsolete or can we up grade it to windows 10.
There is no information in the provided context about upgrading the Asus Eee PC 4G (701) to Windows 10.
To resolve internet connectivity issues on this model:
- If using a wired PPPoE connection:
1. Follow steps 1-2 of "Using a static IP" to start the PPPoE configuration.
2. Select the connection type and click Next.
3. Choose the hardware for the connection and click Next.
4. Enter your username and password and click Next.
5. Name the connection and click Next.
6. Click Finish to apply settings and enable automatic connection if needed.
- If using a wireless PPPoE connection:
1. Follow steps 1-2 of "Using a static IP" to start the wireless PPPoE configuration.
2. Select the connection type and click Next.
3. Choose the hardware for the connection and click Next.
4. Enter the wireless channel information and click Next.
5. Set the encryption information and proceed.
If problems persist, contact your internet provider.
This answer is automatically generated