Malfunctions; Transport; Disposal; Troubleshooting - Taski swingo 755B power Manual

Malfunctions

Malfunction Possible causes
Machine does not
Maschine switched off
run
Battery/mains
Discharged batteries
unit malfunction
(display on con- Batteries/battery
trol panel) charger defective
Power cord not
plugged in or defecti-
ve
Batteries not suf-
ficiently charged
Batteries or battery
charging unit defecti-
ve
Brush does not Motor runs but not
turn tool
The float closes the
inlet opening at the
suction unit (overfill
protection for recove-
ry tank)
Squeegee not on the
floor
Suction hose not con-
nected
Check the seal on the
tank lid for cracks/dirt
Poor vacuum
performance
Vacuum air filter blo-
cked
Floor remains
wet
Hose or nozzle blo-
cked (e.g. by pieces
Soiled solution
of wood or residual
not picked up
material)
The blades do not ad-
just well to the floor
consistancy
Dirt sieve full (yellow)
Vacuum switched
Recovery tank full
off
Solution tank empty
Insufficient out-
flow of cleaning
Solution tank filter blo-
solution
cked
Foam or liquid
leaking from the Float malfunction
machine
44

Troubleshooting

page
• Switch on the
keyswitch.
37
• Connect the battery to
the machine with the
37
battery disconnection
socket.
• Recharge batteries
38
• Call for technical
assistence
• Plug in the power cord
• Call for technical
assistence
• Call for technical
assistence
• Call for technical
assistence
• Check the recovery
41
tank is not full
• Check that the float is
43
functioning correctly.
• Lower the squeegee.
41
• Connect suction hose
• Clean the seal, or
replace if defective
• Remove the blockage
• Remove the blockage
• Clean the squeegee
• Change/turn the
43
blades
• Check that the
squeegee suspension
is functioning correctly
• Remove the dirt sieve
• Knock out the coarse
41
dirt from the sieve and
rinse it under running
water.
• Empty the recovery
41
tank
• Fill the solution tank
40
• Clean solution tank
42
filter
• Turn off the suction
37
aggregate
• Check that the float is
43
functioning correctly.

Transport

Transport the machine in an upright position and remove the batteries for
transportation where necessary.
Ensure that the machine is firmly lashed down and secured in the transport
vehicle.

Disposal

When it has reached the end of its operational life, the machine and its
accessories must be disposed of according to the national regulations. Your
TASKI partner can support you with proper disposal upon notification.
Batteries
The batteries must be removed from the machine before being disposed of
properly.
Used batteries must be disposed of in an environmentally appropriate way in
accordance with the EU guidelines 2006/66/EEC.

Technical data

Machine swingo
755
type CO755.1/
CO755.1X
Theoretical performance 1935
area operation width x
drive speed (4,5) x 1000
Working speed 4.5
Working width 43
Squeegee width 69
Solution tank nominal 40
Recovery tank 40
Machine weight for 160
operation
Rated voltage 24V
Tools 1 x 43
Brush rpm 165
Brush pressure 43
Dimensions (L x W x H) 116x47.5x
119.5
Rated power 900
A-weighted emission <70
sound pressure level
ISO 11201
Vibrationtotal value of the <0.5
Hand-Arm system
ISO 5349
Splash water protection IPX3
Protection class without
battery charger (only
model: CO1255.1/
CO1255.2)
Protection class (without III
battery charger). Only
model: CO755.1/
CO855.1
Protection class with I (II)
battery charger
swingo swingo
855 1255
CO855.1/ CO1255.1/
CO855.1X CO1255.1X
2250 2475 m2/h
4.5 4.5 km/h
50 55 cm
69 80 cm
40 60 l
40 60 l
160 260 kg
24V 24V DC
1 x 50 2 x 28 cm
165 195 min-1
43 48 kg
122x53x 142x58x117 cm
119.5
900 1000 W
<70 <70 dB(A)
<0.5 <0.5 m /s2
IPX3 IPX3
III
III
I (II) I (II)