Download Print this page

IXL 10174 hotline Installation & Operating Instructions

Semi recessed electric space heater

Advertisement

Quick Links

CONGRATULATIONS ON PURCHASING OF BACKWELL IXL ELECTRIC SPACE HEATER

Operation instructions

INTRODUCTION
For satisfactory performance of your IXL electric space heater please read these instructions carefully.
To save on running costs you should insulate the ceilings of your home. This will help keep your home
warm in winter and cool in summer.
For additional assistance in the use of your heater contact your electrical authority showroom, the
manufacturer or State Distributor.
CONTROLS:
(i) 2 switches on heater controlling:
-ON/OFF switch (red illuminated)
- HI/LO switch (red) which selects one or both elements
(ii) Remote thermostat (wall mounted)
TO HEAT:
Switch ON the red ON/OFF switch.
When power is on the ON/OFF switch is illuminated.
warmup using both heating elements simply
switch HI on the HI/LO switch.
Set thermostat to 20°C.
The heater will operate and cycle on and off to maintain steady temperature in the room. Individual
requirements may require adjustments to thermostat setting but for economy use the lowest setting at
which comfort is obtained.
When the room has reached comfort level, select "LO" on the HI/LO switch and use this selection
whenever possible for optimum distribution and economy. For best results and comfort, do not sit too
close to heater or obstruct outlet with furniture.
Note:
The heater will not operate unless the room temperature is below that selected on the thermostat.
TO TURN THE HEATER OFF:
Simply switch off the red illuminated ON/OFF switch. DO NOT TURN DOWN THE THERMOSTAT.
BACK VENT OPERATION:
(B.V. Models only)
Warm air can be directed in either or both directions in any proportion. To heat main room pull chain in
rear register outwards to full extent and lock in position.
To obtain heat through rear register disengage chain and allow chain to be drawn back into register. Lock
chain at any desired position. When heating both main room and rear area, use only "HI" selection.
When Fitted with Dual Thermostat Only:
To heat one area only adjust rear register chain for one direction only.
Turn thermostat in unheated area to minimum setting. Adjust thermostat in heated area to obtain
desired temperature.
To heat both areas select temperature required in each area. Adjust rear register chain to give balanced
heating. Correct position will be found by trial and error.
CLEANING AND MAINTENANCE:
The only moving part in your heater is the fan unit which is designed for long life. To maximize the life
of the heater we recommend that it be cleaned internally by a qualified electrician/service agent every
two years or as required.
IMPORTANT
: During maintenance and service ensure heater is electrically isolated.
All external surfaces should be cleaned using warm water and mild detergent. Do not use abrasives as
scratching will occur.
Owners Warranty and Service Record
Complete and keep the following information as it is vital for warranty claims and service calls.
Ensure you maintain proof of purchase including date.
Cat./Model Number ............................................ Serial Number ..........................................................
Date Purchased .......... /................ /............. Installed by ....................................................................
Safety Information
For safe operation of your heater, please ensure you observe the following points:
1. Do not cover or obstruct the air vents of the heater.
2. Do not place any large obstructions within 1 metre of the front of the heater.
3. Do not insert objects through the air vents of the heater.
4. Never drape the heater with clothes or other combustible materials.
5. Never use the heater in the vicinity of paint thinners, petrol or other combustible liquids.
6. The heater is not intended for use by young children or infirm persons without supervision.
7. Young children should be supervised to ensure they do not play with the heater.
8. Do not allow water to splash on the heater. If the heater appears to be dump, do not switch the power
on.
9. Keep top and bottom air inlet and outlet grilles clear and unobstructed - clean externally with
vacuum cleaner.
Additional Warning
To give faster
Before using your IXL space heater for the first time or if the heater has not been used
recently, the area where the heater is used MUST be well ventilated for at least 2 hours.
As with any new heating appliance, certain effects such as faint odour may occur. These are
part of the NORMAL running-in process and will disappear.
Service
If the unit fails to function, before calling for service please check the following:
1. Check that switch is ON and neon indicator is glowing
2. Check that the electrical supply is on at the switchboard and the fuse is intact
3. Check that the thermostat is set correctly
Should the unit require service, please contact your nearest IXL Service Centre:
IXL Appliances Service Division
A division of Backwell IXL Pty Ltd ACN 005 326 009
PO Box 818, Geelong, Victoria 3220
1800 032 558
FAX
1800 032 024
IMPORTANT: The Warranty does not cover service calls related to incorrect operation. Should the unit
require service, switch it off and contact the manufacturer or state distributor.
Warranty
The benefits conferred by this warranty are in addition to all other rights and remedies in respect of
the product which the consumer has under the Trade Practices Act and similar state and territory laws.
Under this warranty, for a period of two years from the date of purchase, IXL Appliances undertake to
replace or make good any parts which are proven to be defective. The warranty applies only if:
1. The unit is installed and used in accordance with the manufacturer's instructions.
2. The defects were not caused by changes or modifications made by unauthorised persons.
EXCLUSIONS:
This warranty does not cover damage or loss caused by:
a. Misuse, negligence or faults due to incorrect installation
b. Improper wiring circuits or fuses
c. Attempts to repair the appliance by unauthorised people
d. Failure to install and maintain the appliance in accordance with the manufacturer's instructions.
The benefit conferred by this warranty are in addition to all other rights and remedies in respect of the product
which the consumer has under the Trade Practices Act and similar state and territory laws.
Manufactured & Warranted by:
BACKWELL IXL Pty Ltd. A.C.N. 005 326 009
Wood Street, East Geelong, Victoria, 3219, AUSTRALIA
APPLIANCES
Tel: 1800 032 558 Fax: 1800 032 024
IXL Appliances NZ Ltd
PO Box 100755,
North Shore Mail Centre, Auckland
0800 806 664
FAX
(09) 476 0028
6kW Models: 10176 Hotline,
P/No.611131
APPLIANCES
Installation
& Operation
Instructions
Hotline
& Classic
Semi Recessed
Electric
Space Heater
4.5kW
Models: 10174 Hotline, 10634 Classic
10636 Classic, 10646 Classic with Timer

Advertisement

loading
Need help?

Need help?

Do you have a question about the 10174 hotline and is the answer not in the manual?

Questions and answers

Summary of Contents for IXL 10174 hotline

  • Page 1: Operation Instructions

    To give faster warmup using both heating elements simply switch HI on the HI/LO switch. Before using your IXL space heater for the first time or if the heater has not been used & Operation Set thermostat to 20°C. recently, the area where the heater is used MUST be well ventilated for at least 2 hours.
  • Page 2 External wiring: Please read these instructions completely before commencing installation To set jacknut drill 9.5mm (3/8“) diameter hole in wall Jacknut in wall cladding. Push jacknut into hole. Pass metal thread screw Isolating switch to be installed in accordance Bridge Installation through friction wrench and into jacknut.

This manual is also suitable for:

10176 hotline10636 classic10634 classic10646 classic with timer