Troubleshooting For Anynet - Samsung 450 User Manual

troubleshooting for anynet

Symptom
anynet + does not work.
I want to start anynet + .
I want to exit anynet + .
the message "Connecting to
anynet + device..." appears on the
screen.
the anynet + device does not play. You cannot use the play function when Plug & Play is in progress.
the connected device is not
displayed.
the tV program cannot be
recorded.
+
Solution
Check if the device is an Anynet + device. The Anynet + system supports Anynet +
■
devices only.
■ Connect only one receiver (home theater).
Check if the Anynet + device power cord is properly connected.
■
Check the Anynet + device's Video/Audio/HDMI cable connections.
■
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
■
■ Check whether the TV remote control is in TV mode.
Check whether it is Anynet + exclusive remote control.
■
Anynet + doesn't work at a certain condition.
■
■ When connecting or removing the HDMI cable, please make sure to search devices
again or restart your TV.
Check if the Anynet + Function of Anynet + device is set on.
■
Check if the Anynet + device is properly connected to the TV and check if the Anynet +
■
(HDMI-CEC) is set to On in the Anynet + Setup menu.
■ Press the tV button on the TV remote control to switch to TV. Then press the toolS
button to show the Anynet+ menu and select a menu you want.
Select View tV in Anynet+ menu.
■
■ Press the SourCE button on the TV remote control and select a device other than
Anynet + devices.
■ Press any of Ch</>, PrE-Ch to change the TV mode.
(Note that the channel button operates only when a tuner-embedded Anynet + device
is not connected.)
You cannot use the remote control when you are configuring Anynet + or switching to a
■
view mode.
Use the remote control when the Anynet + setting or switching to view mode is
■
complete.
Check whether or not the device supports Anynet + functions.
■
■ Check whether or not the HDMI cable is properly connected.
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
■
Search Anynet + devices again.
■
You can connect an Anynet + device using the HDMI cable only. Some HDMI cables
■
may not support Anynet + functions.
■ If it is terminated by an abnormal situation such as disconnecting the HDMI cable or
power cord or a power failure, please repeat the device scan.
Check whether the antenna jack on the recording device is properly connected.
English - 54
(Searching channels, Plug & Play, etc.)