Using Your Ceiling Fan - Tommy Bahama CABRILLO COVE Instructions Manual

15.1
WARNING
!
Fan installation must be completed, including the
installation of the fan blades, before testing the
remote control.
Check the operation of the fan light by pressing and
releasing the light control button.
Press and hold the light button to check the dimming
control is functioning as desired per the switch setting
during the programming of the transmitter.
Press and release the light button to turn the light OFF.
Press the OFF button to stop the fan.
15.3
You should have the following uninstalled spare hardware
remaining on the work surface:
1. One downrod of either 4.5 in. / 11.4 cm. 2b or 18 in. /
45.7 cm. 3 .
2. One #10-24 x 0.4 in. / 1.0 cm. pan head shoulder screw
18 .
3. One 1/8-27 NPS x 0.3 in. / 0.8 cm. pan head screw
19 (if light kit was installed).
4. One 1/4-20 x 0.5 in. / 1.3 cm. pan head shoulder screw
20 with integrated washer 21 .
5. One #8-32 x 0.3 in. / 0.8 cm. flat head screw 22 .
6. Three small yellow wire connectors 12c .
Tommy Bahama • 04/2013

15. Using Your Ceiling Fan

15.2
All fans are shipped from the factory with the reversing
switch positioned to circulate air downward. The reverse
switch is located on the side of the switch cover just below
the blade holders. The switch is covered with a soft rubber
seal that protects it from water. If airflow is desired in
opposite direction, turn your fan off and wait for the blades
to stop turning, then slide the reversing switch to the
opposite position, and turn fan on again. The fan blades
will turn in the opposite direction and reverse the airflow.
Reverse Switch Information
Season Rotation
Direction
Summer Counter-Clockwise
Winter Clockwise
REVERSE
SWITCH
2b
3
20
18
21
19
35
email@carrollparts.com • 1-800-875-3545
Switch
Position
Right
Left
22
12c