Menu Setting Pellet - CTC Union ecoflex Installation And Maintenance Manual

End user information
Setting Heating
Max Primfl °C
►
Min Primfl °C
Heating off
Heat curve
Inclination
Adjustment
Setting pellet
Level sensor %
►
Flame detector %
Burner type kW
Power full auger %
Power full fan %
Power part auger %
Power part fan %
Power min auger %
Power min fan %
Holding min
Auger Feeder s
Sequenz code
Level sensor%
Set. tank
Charge tank
►
Temp tank °C
Diff °C
Tank prio
Flame detector %
Functiontest pellet
Auger Feeder
►
Fan %
Auger burner %
El ignition
Burner type kW
Funct. test other
Power full auger %
ElRelay 1,5/3 kW
►
ElRelay 3/6 kW
Power full fan%
Pellet
Heatingcirpump.
Power part auger %
MixingValve
DHW pump
Power part fan %
Diode sensor
Alarm stored
Power min auger %
Last alarm
xxxxx
Power min fan %
Stored alarm
xxxxx
Holding min
xxxxx
xxxxx
xxxxx
Auger Feeder s
Sequenz code
26
CTC EcoFlex
55
Off
16
50
0
3.13

Menu Setting pellet

0(50)
(Installer/Setting/Setting pellet)
99(50)
15
Pellet burner parameters are set in this menu. CTC EcoFlex is supplied with
68
the pellet burner set for most normal heating systems. Changes are only to
40
41
be made to the pellet burner by qualified installation engineers or service
20
technicians.
0
0
60
30
0
The value is the signal strength measured (%) in the level monitor receiver.
0 0(50)
Yes
The value in brackets is the limit at which the control system interprets the
70
signal from the level monitor receiver as being on or off. Value 0 means
5
free passage between the flame detector transmitter and the level monitor
No
receiver, i.e. no pellets in the top connection. Value 99 means that the beam
between the level monitor transmitter and receiver is fully interrupted, i.e.
there are pellets in the top connection.
The value is measured light strength (%) in the flame detector. The value in
99(50)
brackets is the limit at which the control system interprets the signal from
Off
0
the flame detector as meaning there is or there is not a flame. Measured
0
value = 1, the flame detector does not detect light. Measured value = 99,
Off
the flame detector detects a strong flame.
The burner factory settings are full load 15 kW, part load 9 kW and min load
15
0 kW. 20 kW not in use.
Factory set value to full load 15 kW
68
0
0
Factory set value to full load 15 kW.
40
Off
Off
Factory set value for part load 9 kW.
41
Close
Off
Factory set value for part load 9 kW.
20
Off
Output mode min is blocked at delivery.
0
Output mode min is blocked at delivery.
0
The time in minutes between each feed of pellets when the burner is in the
60
holding mode (i.e. no heat output from the boiler).
The time in seconds which the external feed auger runs each time it
30
receives a signal from the level monitor to fill pellets to the burner top
connection.
Contains important factory set values for the burner function.
0
Must not be changed.