NEC Univerge SV8100 Programming Manual page 52

Issue 1.0
Item
No.
14
15
16
17
18
19
20
21
2 - 12
Item
13 Loss-Of-Signal Detection Limit
If the transmit/receive voltage is less
than the setting in 10-03-13, the system
considers this as Loss-Of-Signal and
the PRTA does not come up. Note that
there are different values based on the
setting in 10-03-12 for the PRI.
--- Not Used ---
--- Not Used ---
--- Not Used ---
ISDN Ringback Tone
If Telco does not provide ringback tone,
SV8100 can if 10-03-17 is set to
1:Enable.
Type of Number
ISDN Protocol definition.
Select the number type for the ISDN
circuit.
Numbering Plan Identification
ISDN Protocol definition.
Select the Numbering Plan used for the
ISDN circuit.
Network Exchange Selection
Select the ISDN protocol for the ISDN
circuit.
Number of Ports
Input Data
0 = Level 0 (lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7 (highest sensitivity)
0 = Disable
1 = Enable
0 = Unknown
1 = International number
2 = National number
3 = Network Specific number
4 = Subscriber number
5 = Abbreviated number
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering
plan
5 = Private numbering plan
0 = Standard (same as NI-2)
1 = reserved
2 = reserved
3 = DMS (A211)
4 = 5ESS
5 = DMS (A233)
6 = 4ESS
7 = NI-2
0 = Auto
1 = 4 Ports
2 = 8 Ports
3 = 12 Ports
4 = 16 Ports
5 = 20 Ports
Program 10 : System Configuration Setup
UNIVERGE SV8100
Default
2
1
2
1
0
0