Dear Customer: You have purchased a well-designed contemporary wood burning product. You will find that your ARDENT ENERGY A U R 0 R A will give you comfortable controlled heat in your home for years to come. It is in your best interest to become familiar with your ARDENT ENERGY heating system. Study your installation manual carefully before attempting to install your heating system.
AURORA OWNERS MANUAL until frequency of cleaning requirements is established. SAFETY INSTRUCTIONS If creosote has accumulated it should be removed to reduce the risk of a chimney fire. WARNING! IN CASE OF A CHIMNEY FIRE: THESE OPERATOR SAFETY INSTRUCTIONS SHOULD BE READ CAREFULLY! 1.
Metal chimneys must be suitable for wood burning appliances and masonry chimneys must be lined with an approved liner. ARDENT ENERGY heating units burn very efficiently, resulting in lower than usual flue gas temperatures. As a consequence, outside installation of the chimney is not recom-...
AURORA OWNERS MANUAL cause a back draft and/or promote creosote formation. hole saw through floor. If an existing chimney is to be used, it must be inspected carefully Position the heater on floor shield over hole. Fasten for soundness and to assure that it meets the above specifications.
RELOADING: INSTRUCTIONS Have fuel on hand to load firebox. ARDENT ENERGY units are especially designed for controllabil- Open the door SLOWLY. Allow the chimney to draw off ity. With the optional thermostat kit, your house will be heated to smoke.
AURORA OWNERS MANUAL MAINTENANCE DAILY: DRAFT CONTROL: heck chimney and pipe for creosote build-up until experience Check that it opens and closes freely. shows how often cleaning is necessary. Periodically run unit at maximum for 30 minutes to bake any creosote in the chimney and pipes.
AURORA OWNERS MANUAL OPTIONS Thermostat Kit (part # FC-HC2) Blower (part # FC-HB4) WALL THERMOSTAT KIT (Model FC-HC2) The control system consists of an electric damper control unit and a wall thermostat. Installation: Remove rear heat shield by unscrewing 4 screws.
Need help?
Do you have a question about the Aurora and is the answer not in the manual?
Questions and answers