Replacing The Filters - Sunbeam SCM7809-CN Instruction Manual

F E AT U R E S - O P E R AT I O N S
MANUAL MODE INSTRUCTIONS
1. Plug the humidifier into a 120V AC electrical outlet.
2. To start the unit, push the MODE/OFF button
( ) once for the HIGH (HI) manual setting.
3. Press the button again for the LOW (LO)manual
setting.
4. To stop the unit, press and hold the button for two
seconds, or keep pressing the button until all the
humidity indicators are OFF.
NOTE: In Manual Mode, only the LO or HI power light
will be lit.
1TOUCH HUMIDISTAT INSTRUCTIONS
TM
To take advantage of the 1Touch
press the MODE/OFF button (
set in either the HI or LO setting, and the Desired
Humidity is set. When the humidity level rises above the
set humidity, the humidifier will stop. When the humidity
level drops below the set humidity, the humidifier will
turn on automatically.
NOTE: When the 1Touch
either the LO or HI power light and the percent humidity
light will remain lit during operation.
NOTE: Allow up to 30 minutes for the filter to fully
absorb water and for the unit to produce moisture.
NOTE: The 1Touch Humidifier has memory. This means
TM
that when you turn the unit back on, it will be at the last
setting the humidifier was set at.
If you do not plan to use the humidifier for two or more
days, make sure any residual water is drained from the
water tank, base and wick filter to prevent algae or
bacteria growth.
EXTENDED RUN TIME SETTING
By setting your humidifier to a specific humidity level,
you are actually also extending the run time. Since the
unit will turn on and off to maintain the set humidity
level, less water will be used than on manual setting.
Electronic Humidistat,
TM
) until the speed is
Electronic Humidistat is set,
TM
Figure 1
D
G
A
F
H
A. Humidifier Tank
B. Humidifier Housing
C. Control Panel
D. Tank Handle
E. Humidifier Base

REPLACING THE FILTERS

Through normal use, waterborne minerals and sediment
become trapped in the wick filters. The harder your
water, the greater the amount of minerals in the water,
and the more often you will need to change your filter.
You will be able to monitor the life of the filters in your
humidifier by checking the FilterCheck
NOTE: After 60 minutes of use, FilterCheck
will move and indicate your
filters condition.
New filters will register in the
section reading Good filter.
After frequent use of your
humidifier, the FilterCheck
Indicator will let you know
when the filters need to be
changed, see Figure 2.
When the needle is in the CHANGE section, this means the
proper amount of moisture is not getting into your air
due to the excessive minerals and sediment that have
become trapped on your filters. At this point, you should
replace your filters. It is important to change your filters
as indicated to obtain stated performance level.
To replace the filter, follow the steps below:
1. Turn the unit off and disconnect from the electrical
outlet.
F. 1Touch Button
TM
G. Humidity Set Lights
H. Speed Indicators (HI/
LO)
I. FilterCheck Indicator
TM
Indicator.
TM
Indicator
TM
Figure 2
TM
I
B
C
E