GE 14 Owner's Manual page 26

Removing the doors/Reversing the hardware.
Read these instructions completely and carefully.
Remove the Fresh Food Door
Tape the door shut with masking tape.
1
Using a 5/16" hex-head socket screwdriver and a 5/16" open-end wrench,
2
remove the two screws holding the center hinge (and the shim glued to it) to
the cabinet. Lift the center hinge to free its pin from the socket in the top of
the door, and set hinge and screws aside.
Remove the tape and tilt the door away from the cabinet. Lift the door from
3
the pin in the bottom hinge bracket. (If the plastic washer sticks to the door
bottom, put it back on the hinge.)
Set the door outside-up on a non-scratching surface.
4
Using a Torxdriver, transfer the two screws from the opposite side of the
5
cabinet to the screw holes vacated by the center hinge removal.
Take one of the screws removed in step 2 and start it in the outermost screw
6
hole on the opposite side. Do not drive it all the way down—leave enough
space under the screw head for thickness of shim and bracket.
Transfer Bottom Hinge to the Left
Remove the base grille (if your refrigerator has one) by pulling it straight
1
out.
Using a Torxdriver, move the bottom hinge bracket (and the shim glued to
2
it) and plastic washer from the right side to the left side.
26
Center Hinge Bracket
Hinge Bracket
Hinge Pin
Plastic Washer
Plastic Washer