System Memory - Viglen D965GF Quick Start Manual

CAUTION: Do not move any jumpers with the power on. Always turn off the
power and unplug the power cord from the computer before changing a
jumper setting. Otherwise, the board could be damaged.
Figure 5 - Location of the BIOS Configuration Jumper Block
The three-pin BIOS jumper block enables all board configurations to be done
in the BIOS Setup program. The table below shows the jumper settings for the
BIOS Setup program modes.
Table 5
Function/Mode Jumper Setting
Normal (default)
Configure
Recovery
Note: The Default AMT 2.0 (Intel ® Management Engine) BIOS password is:
admin (all lower case)

System Memory

The BIOS uses current configuration
1-2
information and passwords for booting.
After the power-On Self-Test (POST) runs,
the BIOS displays the Maintenance menu.
2-3
Use this menu to clear passwords.
The BIOS attempts to recover the BIOS
configuration. A recovery diskette is
None
required.
Page - 12 - of 21
Configuration