Subscribe to Our Youtube Channel
Related Manuals for Xtreme Power Conversion S70 Line?Interactive
Summary of Contents for Xtreme Power Conversion S70 Line?Interactive
- Page 1 UNINTERRUPTIBLE POWER SUPPLY (UPS) S70 Line‐Interactive Low Voltage Tower Models USER & INSTALLATION MANUAL www.xpcc.com | © 2012 Xtreme Power Conversion Corporation. All rights reserved. ...
-
Page 2: Package Contents
S70 SERIES USERS MANUAL V2 Package Contents You should be receiving the following items inside the package: UPS Unit User Manual Local Monitoring Software CD USB cable Product Introduction Thank you for selecting this uninterruptible power supply (UPS). It provides you with protection for connected equipment. Please read this manual before installing the S70‐Series UPS models S70‐ 500, S70‐700, S70‐1000, S70‐1500, and S70‐2000 as it provides important information that should be followed during installation and maintenance of the UPS and batteries, allowing you to correctly ... - Page 3 S70 SERIES USERS MANUAL V2 systems from poor quality utility power, complete loss of power, or other associated problems. Electrical interference exists in many forms, causing problems in AC power, from lightning, power company accidents and radio transmission motors, air conditioners, and vending machines. Protection of sensitive electrical equipment is vital to protect against power outages, low or high voltage conditions, slow voltage ...
- Page 4 S70 SERIES USERS MANUAL V2 When AC input power returns, the UPS automatically begins supplying the load with power through the AVR circuit. The charger circuit provides recharge for the batteries. Xtreme Power Conversion® (XPC) Corporation 4 ...
- Page 5 S70 SERIES USERS MANUAL V2 Xtreme Power Conversion® (XPC) Corporation 5 ...
- Page 6 S70 S SERIES USERS S MANUAL V2 Inst tallation & Initial Sta artup Before in nstallation, i inspect the u unit and pac ckaging to ke sure that n nothing insid de has been damaged. Plac cement & St torage Insta all the UPS in n a protecte d area that i is free of exc cessive dust and has adequat te air flow. P Place the UP PS away from m other units s at least t 7.8 in (20 c cm) to avoid ...
- Page 7 S70 SERIES USERS MANUAL V2 Connect UPS to Utility and Charging Before the initial use of the UPS, plug the UPS input cord into a wall outlet and turn the UPS on by depressing the Power switch on the front of the UPS. For best results, the batteries in the UPS should be charged for at least 6 hours before use. The UPS charges ...
-
Page 8: Important Safety Instructions
S70 SERIES USERS MANUAL V2 the UPS. To turn the UPS unit off, press the Power switch on the front of the unit again. Cold Start Function When the UPS is off and there is not input utility power available, it is still possible to cold start the UPS unit to power loads. Follow the instructions for Turning UPS ON and be aware that you will see and hear the ON BATTERY ALARM. IMPORTANT SAFETY INSTRUCTIONS: (SAVE THESE INSTRUCTIONS) CAUTION! (UPS having Internal Batteries): Risk of electrical shock – Hazardous live parts inside this unit are energized from the battery supply even when the input AC power is disconnected. ... - Page 9 S70 SERIES USERS MANUAL V2 Servicing of batteries should be performed or supervised by personnel with knowledge of batteries and the required precautions. Keep unauthorized personnel away from batteries. The instructions contained within this safety manual are deemed important and should be closely followed at all times during installation and follow‐up maintenance of the UPS and batteries . Xtreme Power Conversion® (XPC) Corporation 9 ...
-
Page 10: Troubleshooting
S70 SERIES USERS MANUAL V2 Troubleshooting Condition Visual Indicator Alarm Charge the UPS at least 6 Low battery hours Replace the battery with No words display on Battery fault the same type of battery front panel The UPS is not Press the Power Switch turned on on the front of the UPS Alarm continuously Remove some of the load The UPS is sounds when the AC from the output of the overloaded input is normal UPS Remove some of the load The UPS is from the output of the overloaded UPS Battery voltage is Charge the UPS at least 8 When power fails, too low hours backup time is shorter Battery defect – than expected possibly due to high environmental ... -
Page 11: Specifications
S70 SERIES USERS MANUAL V2 Specifications 120V Model S70-500 S70-700 S70-1000 S70-1500 S70-2000 Voltage 120VAC (81-145) Capacity VA 500VA 700VA 1000VA 1440VA 2000VA INPUT (300W) (420W) (600W) (900W) (1200W) Frequency 60 Hz auto sensing Voltage 120VAC (108-132) Waveform Simulated sine wave OUTPUT Frequency 60 ±... -
Page 12: Indicators & Alarms
S70 SERIES USERS MANUAL V2 120V Model S70-500 S70-700 S70-1000 S70-1500 S70-2000 Operating 32-104F (0-40ºC) Temperature Humidity 0%-90% ENVIRONMENT Audible < 40dB Noise Altitude 11,500 ft (3500 m) above sea level AC Mode, Battery Mode, Load Level, Battery Level, Input LCD Display Voltage, Output Voltage, Overload, Fault, Low Battery Battery Mode Alarm sounds every 10 seconds Low Battery... -
Page 13: Obtaining Service
S70 SERIES USERS MANUAL V2 Obtaining Service If the UPS requires Service: 1. Use the TROUBLESHOOTING section in this manual to eliminate obvious causes. 2. Verify there are no circuit breakers tripped. 3. Call your dealer for assistance. If you cannot reach your dealer, or if they cannot resolve the problem, call Xtreme Power Conversion Corp Technical Support at 800.582.4524. Technical support inquiries can also be made at support@xpcc.com. Please have the following information available BEFORE calling the Technical Support Department: a. Your name and address. b. The serial number of the unit. c. Where and when the unit was purchased. d. All of the model information about your UPS. e. Any information on the failure, including LED’s that may or may not be illuminated. f. A description of the protected equipment, including model numbers if possible. ... - Page 14 S70 SERIES USERS MANUAL V2 XTREME POWER CONVERSION (XPC) CORPORATION LIMITED WARRANTY ® Xtreme Power Conversion (XPC) Corporation warrants Xtreme Power Conversion equipment, when properly applied and operated within specified conditions, against faulty materials or workmanship (excluding batteries) for a period of three years for S70‐Series products from the date of purchase. XPC Corporation warrants internal batteries ...
- Page 15 S70 SERIES USERS MANUAL V2 XTREME POWER CONVERSION LOAD PROTECTION POLICY ® For Standard EPC 120, 208 and 240 Volt Products used in the United States and Canada THIS POLICY IS NOT A WARRANTY. REFER TO THE XPC CORPORATION, INC. LIMITED WARRANTY FOR INFORMATION CONCERNING THE WARRANTY FOR YOUR XPC PRODUCT. THE LIMITATIONS AND CONDITIONS CONTAINED IN THIS POLICY DO NOT AFFECT THE TERMS OF THE XPC LIMITED WARRANTY. Definitions: “Product” means an XPC Standard EPC 120, 208, or 240 Volt power protection device that is used in the United States and Canada. This policy does not include custom manufactured products. “Power Disturbance” means an AC power line transient (telephone line, local Area Network or CATV transients, if applicable), spike or surge. “Fair Market Value” of damaged Connected Equipment as determined by XPC shall be the lower of (a) the average price the same or similar items are being sold for on eBay, (b) the price list of Orion Blue Book (or if such price list is no longer published, a published or announced price list reasonably selected by XPC), (c) the lowest price the same or similar items can be purchased for in the United States or (d) the total amount ...
- Page 16 S70 SERIES USERS MANUAL V2 All Connected Equipment must be UL or CSA approved. The Product must be plugged into a properly wired and grounded outlet. Use of input surge devices, extension cords, adapters, ground wires, or electrical connections not manufactured by XPC voids the XPC Load Protection Policy. No other surge protection device may be connected to the output sockets of the Product. The installation must comply with all applicable electrical and safety codes set forth pursuant to the NEC. The Product must have undeniable physical evidence of a Power Disturbance that directly and proximately caused the damage; The Connected Equipment must have been damaged by a Power Disturbance on a properly installed, grounded, and National Electric Code, ("NEC"), ...
- Page 17 S70 SERIES USERS MANUAL V2 THE CLAIMS OF THIRD PARTIES, INCLUDING CUSTOMERS, AND INJURY TO PROPERTY. Submitting a Load Protection Policy Claim: Any claim under the Load Protection Policy must be made within 10 days of the date of alleged damage to the Connected Equipment. Call the XPC technical support department at 1‐800‐ 582‐4524 and obtain a Load Protection Policy Returned Material Authorization (RMA) number. Have information on all applicable insurance or other resources of recovery/payment that are available to the Initial Purchaser and the name of the power utility supplier for the location of the Connected Equipment. XPC will forward ...
- Page 18 S70 SERIES USERS MANUAL V2 For more information about Xtreme Power Conversion Corporation products, services, or UPS Selector sizing, please visit www.xpcc.com Xtreme Power Conversion® (XPC) Corporation 18 ...
Need help?
Do you have a question about the S70 Line?Interactive and is the answer not in the manual?
Questions and answers