Table of Contents
Advertisement
Chapter 4
STEP
17.
If an NT1 device has been purchased, locate the
device and unpack.
Note 1: If a NT1 was not purchased go to
Note 2: Three NT1 are used for the VL384.
18.
Locate the dip switch on the rear of the NT1 and
set all to the ON position.
19.
Place the NT1 or the three NT1s on the second
shelf, to the right of the VisuaLink 128/384.
20.
Locate the NT1 power cable. Plug cable into
power strip at bottom of cabinet and feed cable
through cable slot in rear of second shelf. Plug
second end of power cable into power input at rear
of the NT1.
Page 4-8
ACTION
Step
VisuaLink 128/384 Quick Installation Guide
DRAWING
23.
Foam Inserts
1 2 3 4 5
NT1 REAR
NT1
(one for 128)
(three for 384)
POWER
1 2 3 4 5
Polyethylene
Bag
Packing Carton
POWER
U
1 2 3 4 5
VisuaLink 128/384
HEADSET
POWERLINE
B1
B2
POWER
U
Power Connection
NDA-24232 Revision 1.0
Advertisement
Table of Contents
