Remote Control - Seville Classics ULTRASlimline 10222 Instruction Manual

Control Panel
Heater Speed Selection:
There are 3 settings: Auto , Low
power settings
- +
Adjusting the heater temperature: The system will default to Auto mode.
Press the – / + key, to adjust the temperature of the heater.
Remark:
Celsius/Fahrenheit Conversion
Under working mode, press both
unit will be converted between Celsius and Fahrenheit. This setting will be memorized
once the unit is powered off. For this setting to be memorized, the remote control will
also need to be programmed or it will automatically convert to the remote pre-setting.
See remark on page 8.
Oscillating Selection:
Pressing the button will start & stop the oscillation of the fan.
Heater/Fan Control Panel Modes
FAN MODE
Timer Time Duration
Fan Mode ECO / LOW / MEDIUM / HIGH Oscillating
If "E3" appears on the LCD display, eliminate any obstacles near the
back air inlet grille. Unplug the heater fan for 10-20 minutes (until cool),
then plug back in to resume use.
7
and High . Press to switch between the
and either – or + for 2 seconds, the temperature
HEATER MODE
Heat Mode Temp Timer Time Duration
LOW / HIGH / AUTO
ON/OFF: Turns power ON & OFF
(10 second air blow after shut down)
ECO
High
Heater Speed Selection: There are 3 settings: Auto , Low
Press
- +
- +
Oscillating
Low Medium
Oscillating Selection: Pressing the
button will start & stop the oscillation of
the fan.
to switch between the power settings
Adjusting the heater temperature: The system will default to Auto mode.
Press the – / + key, to adjust the temperature of the heater.
Remark:
Celsius/Fahrenheit Conversion
Under working mode, press both and either –
temperature unit will be converted between Celsius and Fahrenheit. This
setting will be memorized once the unit is powered off.
Setting the Timer: There are 48 total settings. The time can be set
in 1/2 hour increments with each push of the button. 1/2 hour, 1
hour, 1-1/2 hour, 2 hours, up to 24 hours. To set the timer, hold
down the button for 2 seconds, then add or reduce time on the
clock.

Remote Control

and High .
or + for 2 seconds, the
8