NEC Express5800/320Fd-MR N8800-123F, EXP320K User Manual page 472

8-38 System Upgrade
3.
Configure transmitting speed and Duplex mode for the driver
TIPS:
If the check box in [Internet Protocol (TCP/IP)] is unchecked, first check
an then configure the IP address.
(1) Launch Device Manager
(2) Expand network adapter and double click [Stratus emb-EB 2-Port Gigabit Adapter].
(3) Double click [Link speed] tab, then configure [Speed and Duplex] to match the value
on the hub.
(4) On network adapter property, click [OK] at dialog box.
(5) By the same procedure, configure another [Stratus emb-EB 2-Port Gigabit Adapter #2]
Add/delete protocol or services if needed. On [Network Connections], go to Local Area
connection property's dialog box.
TIPS:
[Network monitor] is recommended to add as one of the services.
[Network monitor] can monitor frames (or packets) sent and received a
computer that installs [Network monitor]. This is a useful tool to analyze
network failure. Refer to [Setup for failure managing] for the installation
procedure.
As to the setup of another network port, [Managing port], refer to the
online document [EDPRESSSCOPE Engine 2 User's guide] stored in the
NEC EXPRESSBUILDER DVD.
4.
Set a dual LAN configuration.
Refer to "DUAL LAN CONFIGURATION" on page 3-24.
Now the 1000BASE-T 1ch board set, 1000BASE-SX 1ch board set, or 1000BASE-T 2ch board
set is installed.
N8803-032 SCSI Board
The lists of slots to install optional PCI boards
Refer to the table "List of option PCI boards and installable slots" on page 8-30.
Driver installation procedure
TIPS:
To perform this procedure, you have to log on the system as an Administrator or a member of the
Administrators group.