User Mode Programming - Motorola StarTAC 3000 Service Manual

StarTAC 3000
If a second phone number is to be
programmed, step 11 bit 6 must be set to 1.
This bit enables dual-NAM operation and
will cause NAM programming steps 1-6 and
12 to be repeated for the second phone
number.

User Mode Programming

User Mode NAM programming requires a
special key sequence to enter, but can be
accomplished through the telephone keypad
without the use of any specialized hard-
ware.
The telephone number can be changed only
15 times, after which the phone must be
reset in Manual Test Mode using the 32#
command (erasing all repertory memory.)
Some models may be available with a User
Mode Programming
describes the entry key sequences and the
programming steps for User Mode NAM
programming. User Mode NAM program-
ming steps are different from Test Mode
NAM programming steps, and do not
include all of the option bits available in Test
Mode NAM programming. Access to User
Mode NAM programming can be disabled
by Test Mode NAM programming step 11,
bit C7.
Changed NAM values are not stored
until pressing * after step 16 (step 12
if a second phone number was
entered.)
18
manual which
NOTE
6/29/98