Mix; Auto Sync - LG CM9950 Owner's Manual

24 Operating

MIX

You can mix audio sounds.
1. Press MIX. 'MIXER ON' is displayed.
Select a desired Function for side A and play it.
Mix is available in all functions except USB 2.
2. During playback, insert a USB device in USB port
(B) and play it. Side B is fixed as USB2 function.
3. Move the Mix fader to adjust the sound volume
of mixed sound. Move it to the left to lower the
volume of side B and move it to the right to
lower the volume of side A.
,
Note
3
y In MIXER ON mode,
- You can adjust the Tempo for USB
function 1 or 2.
- If you press Y/U , I or T on the
unit, it works only for each side.
- If you press C/V , d/M or Z
ENTER on the remote control, it works
for both sides A and B.
- For operating, it is recommended to
use Y/U , I or T on the unit
instead of remote control's.
- Numerical buttons do not work.
- You can use H/P MODE. (Refer to page
36)
y If you turn off the unit in the middle of
mixing process, MIX mode turns to OFF.

AUTO SYNC

When using Mixing, you can synchronize the
tempo of audio files being played in USB 1 and
USB 2 by pressing AUTO SYNC.
To stop it, press AUTO SYNC twice.
,
Note
y The tempo of music being played in USB1 is
synchronized to that in USB2.
y A TEMPO doesn't work when AUTO SYNC is
on.
y If USB2 fully stops or function is changed,
AUTO SYNC function is cancelled.
y In case of below, AUTO SYNC error may
occur depending on the sound source.
- The silent section in the beginning of
the track.
- Intro or bridge section in which few
musical instruments appear.
- In cases where playback speed or tempo
of the song changes.
- In case that the data for BPM is provided
in real time, not the beginning of the
song.
y If the song is being played too fast or slow,
press and hold AUTO SYNC. 'AUTO SYNC/
RE-ANALYZING' is displayed.
y AUTO SYNC is available only when USB 1
is selected for side A and USB 2 is selected
for side B in MIXER ON mode and both are
being played.