For Operation; All Off; Faults / Remedies - Silvercrest KH 2156 Operation Manual

For operation

> To operate one of the programmed devices with the URC
first press the corresponding device button e.
Then point the URC to this device and press the desired
button.
> Put the number buttons
original remote control. Before you make a two digit
entry press, if necessary, the
> Press the FAV/EPG button
gramme guide of a device equipped with this function.
> Whilst you hold down the S button
perimposed below to the right in the LCD display q.
> Whilst you hold down one of the device buttons
active code for this device will be superimposed below to
the right in the LCD display q.
> Via the MENU button
setting of the respective target device.

All OFF

Tips:
With the button
are switched on can be automatically switched off. This func-
tion can switch on again devices that have already been
switched off (depending on the device). For this hold down
the ALL OFF button w for approx. 5 seconds. This will only
function under the following circumstances:
1. A visible connection exists between all the devices and
the URC.
2. Automatic code search, brand code search and MACRO
function are not active.
3. All target devices must be suitable for remote control
switch off.
To again switch on all devices automatically hold down once
more the button

Faults / Remedies

Your device does not react to the URC.
> Check the batteries. They must have enough voltage and
be properly installed.
> Firstly have you pressed the correct device button
the desired target device?
> Check to see that the correct code is programmed in for
the target device (see section "Code Setup").
The URC is transmitting the commands incorrectly.
> Press the corresponding device button
to the correct mode.
> The batteries must have enough voltage and be properly
installed.
o exactly as you do with the
l to start the electronic pro-
j you access the dialogue for the
ALL OFF (all off) w all devices that
w until all devices are switched on.
- 21 -
button a.
r the date will be su-
e to set the URC
e the
e for