Panasonic TC-P42G15 Operating Instructions Manual page 45

Check that the network settings are as shown below, and then start "Connection test".
Network setting 112
~
Succeeded
IP
setti~
mode Manual
IP addreas 192168 0 5
Subnet I1\llsk 255 255 255 0
DefaultgBteway 1921680254
CD
Select "Connection test" and press OK.
*Press OK again to cancel the test.
(It takes a while to cancel the test.)
>
~ G)select
'/8~
@ok
. /
Succeeded: "Connection test" succeeded
Only home network:
Home network is available.
Failed: Check the broadband environment connection
and settings and the network settings, and then
perform the test again.
Test in progress
Test not yet performed
•
Z
(1)
~
o
.,
;7\
(j)
(1)
;:;
::::::l
<C.l
,~
<D,elec,
~@Ok
.:~)
(Dchange
~
channel
.... @ok
I
Subnet mask
• Normally, select "Automatic".
• If "Connection test" failed, set the "LAN speed setting"
to "manual" and then select "10BASE half duplex",
"10BASE duplex", "100BASE half duplex" or "100 BASE
duplex".
• Cannot be selected when the "LAN speed setting" is
"Automatic".
• Changing the settings may make it impossible to
connect some types of equipment.
IPaddres.a 19216805
Subnet mask 255 255 255 0
Default g:ataway 1921680254
Network settmg 1/2
C9nnechon test
Succeeded
Network setting 212
~
LAN apeed 108ASE half duple.
Software update
MAC address 123456·78 aO-ab
Network settmg 1/2
COfll'l$Cf:fon
test
Succeeded
CD
Select "LAN speed setting" (Default is "Automatic")
.,.,--~
(Dselect
te
4-
®adiu'l
\t:~l<
/
"T~
,y.
r
CD
Select "DNS setting mode" and set to "Automatic". • Manual setting
(When DNS automatic acquisition in DHCP can be used)
CD
Select "DNS setting mode" and set to "Manual"
G)select
®
Select the item and press OK
/'-/~
@
Enter each IP address as was specified by the
, (;:;;\ _ \ provider.
6---,@ok
, !
I
~
,/ PrimaryDNS
~
J.
®
Each IP address is acquired automatically.
CD
Select "IP setting mode" and set to "Automatic". • Manual setting
(When IP automatic acquisition in DHCP can be used)
CD
Select "IP setting mode" and set to "Manual"
®
Select the item and press OK
@
Check the specifications of the broadband router and
enter each IP address.
i
OMS ..
nina mode
.:.ttlffliffill
d
~
The acquired address is displayed.
®
Each IP address is acquired automatically.
If you are using a broadband router, IP automatic
acquisition in DHCP can be used under normal
circumstances. If you are not sure, check with the
person who installed the equipment, or check the
instructions for each device.
..
-------------~
I
I
I I
0;------1"------'"
The acquired address is displayed.
CD
Select "Software update"
Network setting 212
LAN s~d setting Aulomatlc
l.AN speed 10BASE half duplex
~
MAC address 123456 78-60-ab
_.r--
G)select
/7~
( G-4@Ok
V I
.,
,
®
Press OK to start the software update screen.
@ Follow directions of the screen.
* Set "Clock" first. (p. 18)
• The network settings become effective when you close the menu and run "Connection test".
45