The Finisher Does Not Operate; Stapling Does Not Take Place; The Stapling Position Is Not Correct; Preview Images Or Thumbnail Images Do Not Appear - Sharp MX-C312 Operation Manual

Problem
The finisher does not
operate.
Stapling does not take
place.
Stapling does not take
place.
The stapling position
is not correct.

OTHER PROBLEMS

Problem
Preview images or
thumbnail images do
not appear.
The touch panel
screen is difficult to
view.
Point to check
Does a message appear indicating that
you need to remove paper from the
stapler compiler?
Does the following message appear in
the touch panel?
"Call for service. Code:xx-xx. Finisher
trouble."
*Letters and numbers appear in xx-xx.
Does a message appear instructing you
to check the staple unit?
Does a message appear instructing you
to add staples?
Is a different width of paper mixed in?
Are there more sheets than can be
stapled at once?
Is a paper size that cannot be stapled
included in the print job?
Is the paper type setting of the tray
selected in the printer driver set to a
paper type that cannot be stapled?
Have functions been disabled by the
administrator?
Is the stapling position set correctly?
Point to check
Are there a number of jobs waiting to be
executed?
Is the display contrast properly
adjusted?
Remove all remaining paper from the stapler compiler.
Check the connection cable. Remove and then firmly
reinsert the connection cable, and restart the machine.
Remove jammed staples.
☞
"REMOVING STAPLE
Replace the staple cartridge. Do not forget to replace
the staple case.
☞
"REMOVING STAPLE
Stapling is not possible when paper of different widths
are mixed together. To perform mixed size stapling, use
paper of the same width. When copying, select [Mixed
Size Original] in the special modes.
For the maximum number of sheets that can be stapled,
see "FINISHER
For the paper sizes that can be stapled, see
"FINISHER SPECIFICATIONS" (page 1-43)
Check the paper type settings in the machine and select
a tray that has paper that can be used for stapling*.
Click the [Tray Status] button in "Paper Selection" on
the [Paper] tab of the printer properties window and
check the paper type setting of each tray.
* Stapling is not possible on labels, transparency film, or
envelopes. In addition, if "Disable Staple" is selected in the
user type, stapling will not be possible.
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
Check the stapling position setting.
☞
2. COPIER "OUTPUT" (page 2-34)
Wait until several of the jobs have been executed.
Touch the brightness adjustment key (
system bar in the touch panel to adjust the brightness.
☞
1. BEFORE USING THE MACHINE
BAR" (page 1-13)
8-48
TROUBLESHOOTING
Solution
JAMS" (page 8-13)
JAMS" (page 8-13)
SPECIFICATIONS" (page 1-43)
Solution
"SYSTEM
Contents
) on the