KitchenAid KSS1121 Instructions Manual page 17

7. You hear C02 escaping from
the Carbonator:
• There may be a pressure leak between
the CO_ Carbonator holder and the valve.
Screw the CO2 Carbonator tighter into
its fitting. Do not use tools.
8. If you experience poor carbonation:
• If you have not yet added flavor, try to
carbonate to a higher carbonation level.
• Check the CO_ Carbonator. You might
be out of CO2.
• Make sure that you are carbonating
chilled water.
9. Water overflows from the carbonating
bottle during carbonation:
* Check that the carbonating bottle is filled
just to the fill line.
o Verify that the carbonating bottle is firmly
installed in the Snap-Lock. Check by gently
pulling the bottom of the bottle. [f it feels
loose, then remove and reinsert.
I 0. If your sparkling drink is not
flavorful enough:
• Just add more flavor to taste.
• Do not re-carbonate after adding
the flavor.
I I° Small pieces of ice appear in the
water during carbonation:
• This might happen when carbonating
very cold water. If this happens, shorten
the time of each press until the ice stops
appearing or it can affect the carbonation.
Any ice created will simply melt.
• Ice can form and restrict the flow of
CO2 into the bottle during repeated
heavy carbonation. Allow a few minutes
between carbonating several bottles to
maintain normal carbonation time.
_,WARNING: If you suspect your
Sparkling Beverage Maker is damaged, stop
using it immediately and call for service.
See "Warranty" section for more
information.
12. The gauge is not working:
You may need to replace the batteries as
shown in the "Care and Cleaning'" section.
17