Bosch Classixx 1200 Instruction Manual page 32

Fault
Programme does not
start.
The Ready control light
flashes.
Programme does not
start.
Water does enter the
machine or detergent is hi d t
not washed away. not washed away.
The Active control light
flashes.
Detergent in chamber I is
not washed away.
Water cannot be seen in
drum.
Washing solution is not g
completely drained. The l l d i d Th
End" control light
flashes.
Water is flowing out from
underneath the machine.
Foam coming out of the
detergent dispenser.
The laundry was not spun Large items of clothing became
32
Cause
Loading door not closed.
M Start button not pressed.
Water tap not turned on.
t i
Supply hoses kinked or trapped.
Strainers in supply hoses clogged.
A programme without Prewash was
selected.
This is not a fault.
The water lies below the visible part of the drum.
Loose debris is blocking the pump.
Fluff producing laundry was washed
at a high temperature.
The water drainage pipe or drain
hose is blocked.
The thread of the supply hose is not
tight.
Leak in the drain hose.
To much detergent.
entangled and could not be
distributed evenly in the drum. For
safety reasons, the high speed final
spin cycle was automatically
cancelled.
Action
Check whether laundry is trapped in
door.
Close the loading door (a click
should be heard).
Press the M Start button.
Turn on water tap.
Eliminate the cause.
Clean the strainers
(refer to Page 29).
Select 60 C Cottons + Linens
with Prewash.
Clean the pump (refer to Page 28).
Clean the water drainage pipe
and/or drain hose.
Tighten the thread.
Replace the drain hose.
Mix 1 tablespoon of fabric softener
with ½ litre / 1 pt of water and pour
into chamber II of the detergent dis
penser.
Reduce the amount of detergent
next time.
Always load large and small items
together into the drum (see also
unbalanced load detection system).