Table of Contents
Advertisement
Operating the Teleconference System
In the Teleconference mode, both videos of teleconference can be displayed on a single
2
monitor by PinP.
Connected party
CF
Number display
<Connected party> Teleconference mode
1.
Set the power to ON.
The number display circles, IP address is displayed as shown
on page 48, and then turns off when ready.
4.
The sent number will flash.
Press the PLAY button.
(Connection will not be established unless
this button is pressed.)
The sent number will flash.
For automatic connection without pressing the PLAY
button, set Acceptance in the NETWORK SETUP
screen to Auto.
"HHH" will be displayed if the party is not regis-
tered in TELEPHONE BOOK.
42
ENCODE
DECODE
HOLD
IN 1
IN 2
POWER
Network
Network
PLAY
STOP
HOLD SELECT
P P
in
4.7.
6. 1.
(Off)
-
2.
Number display
<User> Teleconference mode
1.
Set the power to ON.
The number display circles, IP address is displayed as shown
on page 48, and then turns off when ready.
2.
Enter the number of the party to connect
(number registered in Edit No. of
TELEPHONE BOOK screen).
Memo
• Pressing
or
the previous connection.
3.
Press the PLAY button.
User
ENCODE
DECODE
HOLD
IN 1
IN 2
POWER
CF
PLAY
STOP
HOLD SELECT
P P
in
3.7.
6. 1.
(Off)
• Use
and
to select the digit to
input.
• Use
and
to increment/decre-
ment the number of the selected
digit (0~9).
first will display the number of
The entered number will flash.
Advertisement
Table of Contents
