Checking The Front Brake Discs; Installing The Front Wheel (Front Brake Discs) - Yamaha MT-01 T 2005 Service Manual

b. Turn the front wheel 90° so that the heavy
spot is positioned as shown.
c. If the heavy spot does not stay in that posi-
tion, install a heavier weight.
d. Repeat steps (b) and (c) until the front wheel
is balanced.
L LLL L LLL L L LLL L
4. Check:
• Front wheel static balance
M MMM M MMM M M MMM M
a. Turn the front wheel and make sure it stays at
each position shown.
b. If the front wheel does not remain stationary
at all of the positions, rebalance it.
L LLL L LLL L L LLL L
ET5YU1001

CHECKING THE FRONT BRAKE DISCS

Refer to "CHECKING THE FRONT BRAKE
DISCS" on page 4-24.
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
EAS22000
INSTALLING THE FRONT WHEEL (FRONT
BRAKE DISCS)
The following procedure applies to both of the
front brake discs.
1. Install:
• Front brake disc
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
• Front brake discs
LLL
Refer to "CHECKING THE FRONT BRAKE
DISCS" on page 4-24.
3. Lubricate:
MMM
• Oil seal lips
• Collars
4. Install:
• Front wheel
NOTE:
Install the tire and wheel with the mark "1" point-
ing in the direction of wheel rotation.
LLL
5. Tighten:
• Front wheel axle
4-10
FRONT WHEEL
Front brake disc bolt
18 Nm (1.8 m·kg, 13 ft·lb)
®
LOCTITE
Recommended lubricant
Lithium-soap-based grease