Warning Indicators - Sony Bravia HDMI VPL-AW15 Operating Instructions Manual

The I/C) (On/standby) or LAMP/COVER indicator lights up or flashes if there is any
trouble with your projector.
LAMPI
COVER
O~w",~w,---~,mmmw
LAMP/COVER indicator
I/C)
(On/standby) indicator
Symptom Cause and Remedy
LAMP/COVER flashes in ~ Close the lamp cover securely, then tighten the screws securely.
red. (A repetition rate of 2
(Gr
page 56)
flashes) ~ Close the air filter cover securely.
(Gr
page 57)
LAMP/COVER flashes in ~ The lamp has reached the end of its useful lifespan. Replace the
red. (A repetition rate of 3 lamp.
(Gr
page 55)
flashes) .. The lamp has reached a high temperature. Wait until the lamp
cools, and then tum on the power again.
I/C)
(On/standby) flashes .. The fan is broken. Consult with qualified Sony personnel.
in red. (A repetition rate of
4 flashes)
I/C)
(On/standby) flashes ~ The internal temperature is unusually high. Check to ensure that
in red. (A repetition rate of
if nothing is blocking the ventilation holes or whether or not the
2 flashes)
projector is being used at high altitudes.
I/C)
(On/standby) flashes
~ Disconnect the AC power cord, then confirm the
I/C)
in red. (A repetition rate of (On/standby) lamp is turned off. Turn on the power again after
6 flashes)
re-connecting it. If the indicators still light up, the electrical
system has a problem. Consult with qualified Sony personnel.
1m
When a warning indicator other than the above status, consult with Sony Customer Information
Service Center.
53