Sound Settings And Setup Menu; Changing The Sound Settings - Sony CDX-M20 Operating Instructions Manual

Sound Settings and
Setup Menu
Adjusting the sound
characteristics
1
During reception/playback, press the
select button.
2
Rotate the control dial until the desired
menu item appears, then press it.
3
Rotate the control dial to select the
setting, then press it.
4
Press~
(BACK).
The following items can be set:
EQ3 LOW* 1
(page 13)
EQ3 MID* 1
(page 13)
EQ3 HIGH*
1
(page 13)
BALANCE
Adjusts the sound balance: "RIGHT-15
(RlS)"- "CENTER (0)"- ''LEFT -15
(LIS)."
FADER
Adjusts the relative level: "FRONT -15
(FlS)"- "CENTER (0)"- "REAR-15
(RlS)."
SW LEVEL * 2
(Subwoofer Level)
Adjusts the subwoofer volume level:
"+ 10 dB" - "0 dB" - "-10 dB."
("A TT" is displayed at the lowest
setting.)
AUX VOL * 3
(AUX Volume level)
Adjusts the volume level for each
connected auxiliary equipment:"+ 18
dB" - "0 dB" - "-8 dB."
This setting negates the need to adjust
the volume level between sources.
*1 When EQ3 is activated (page 13).
*2 When the audio output is set to "SUB-OUT"
(page 14).
"ATT" is displayed at the lowest setting, and
can be adjusted up to 21 steps.
*3 When AUX source is activated (page 15).
Customizing the equalizer
curve- EQ3
"CUSTOM" of EQ3 allows you to make
your own equalizer settings.
1
During reception/playback, press
( EQ3 )
repeatedly to select
"CUSTOM," then press
~
(BACK).
2
Press the select button.
3
Rotate the control dial until "EQ3
LOW," "EQ3 MID" or "EQ3 HIGH"
appears, then press it.
4
Rotate the control dial to adjust the
selected item, then press it.
The volume level is adjustable in 1 dB
steps, from -10 dB to+ 10 dB.
Repeat steps 2 and 3 to adjust the
equalizer curve.
To restore the factory-set equalizer
curve, press and hold the select button
before the setting is complete.
5
Press~
(BACK).
13