NEC UNIVERGE SV8100 Configuration Manual page 59

UNIVERGE SV8100
IP Trunk – (SIP) Session Initiation Protocol
The UNIVERGE SV8100 IP Trunk SIP package sends the real time voice over the
corporate LAN or WAN. The voice from the telephone is digitized and then put in
frames to be sent over a network using Internet protocol.
Using VoIP equipment at a gateway (a network point that acts as an entrance to
another network), the packetized voice transmissions from users in the company are
received and routed to other parts of the company intranet (local area or wide area
network) or they can be sent over the Internet using CO lines to another gateway.
The PZ-32IPLA/PZ-64IPLA/PZ-128IPLA is
Tie Lines. It can operate in the following modes:
IP Trunk – H.323
H.323 is an International Telecommunication Union (ITU) standard for Packet Based
Multimedia Communication Systems. The UNIVERGE SV8100 can use H.323 to
connect to another UNIVERGE SV8100 system or a third-party product.
The feature set is limited. When using H.323, it is not possible to use the advanced
networking features. If these features are required, use IP KCCIS. The UNIVERGE
SV8100 Voice over IP Trunk blade H.323 package sends the real-time voice over the
corporate LAN or WAN. The voice from the telephone is digitized and then put in
frames to be sent over a network using Internet Protocol.
The UNIVERGE SV8100 Voice over IP Trunk – H.323 blade package allows
communication using standard H.323 (Normal and Fast Start) Protocol and allows
connectivity to any H.323 standards compliant voice gateway and gatekeeper. This
VoIP Trunk blade also allows Registration and Authentication Server (RAS) support to
register with an RAS Server and use Gatekeeper for dynamic call routing.
The PZ-(x)IPLA daughter board – H.323 is an optional interface that can provide IP
trunks and Tie Lines. It can operate in the following modes:
Configuration Guide
COI
COID
DID
TLI
DTI
COI
COID
DID
TLI
DTI
interface that can provide IP trunks and
an
Issue 2.00
2 - 25