Using The Mtx3 To Play Audio Files Saved On An Sd Memory Card; Inserting An Sd Memory Card; Removing The Sd Memory Card; Initializing The Mtx3 - Yamaha MTX3 Owner's Manual

Using the MTX3 to play audio files
saved on an SD memory card
The MTX3 can use commercially available SD memory cards
to play back audio files such as music and sound effects without
needing to connect a CD player or other audio device. The
MTX3 can play back audio files in either MP3 or WAV formats.
Here we explain how to handle SD memory cards. In order to
play back audio files saved on an SD memory card, you must
make settings in MTX Editor. For details, refer to "MTX Editor
User's Manual."
NOTE
Use an SD format or SDHC format memory card (SDXC format
is not supported). However, depending on the manufacturer or
type of memory card, some memory cards might not work cor-
rectly with the MTX3.


Inserting an SD memory card

1. Use a 2.5 mm hex key to open the cover of
the SD memory card slot.
2. With the terminals of the SD memory card
facing downward, insert the card straight
into the slot until it clicks into place.
When the SD memory card has been correctly recog-
nized, the [SD/ACT] indicator (page 9) will light. The
[SD/ACT] indicator will flash while the card is being
accessed.
NOTE
To prevent theft of the SD memory card, we recommend
that you leave the cover installed during use.


Removing the SD memory card

1. Gently press the SD memory card inward.
The card will pop out slightly; gently pull it completely
out.

Initializing the MTX3

Here's how to initialize the MTX3's internal memory, restoring
it to the factory settings.
1. Power-off the MTX3.
2. Set the rear panel DIP switches 7 and 8 to the
"INIT. (INITIALIZE)" position.
3. Power-on the MTX3.
Initialization will start.
The status of execution is shown by the front panel [ALERT]
indicator and the various indicators from [NETWORK]
through [SD/ACT].
• During initialization:
All indicators from [NETWORK] through [SD/ACT]
will flash.
• Initialization completed:
Only the [NETWORK] indicator and the [YDIF] indi-
cator will flash.
• Initialization failed:
The [ALERT] indicator will flash.
CAUTION
Do not turn off the power to the MTX3 during initializa-
tion. Otherwise, a malfunction may occur.
NOTE
If initialization failed, contact Yamaha representatives /
authorized distributors to have the device inspected. A list of
Yamaha representatives / authorized distributors appears
near the end of this manual.
Various Procedures
19
MTX3 Owner's Manual