Using The Power Nozzle; Using The Turbo Nozzle - Electrolux Oxygen User Manual

1
5
9
83
2
6 7
10 11
3 4
8
12
English
G E T T I N G T H E B E S T R E S U LT S
Hard floors: Use the carpet/hard floor nozzle with the lever in
position (1).
Carpets: Use the carpet/hard floor nozzle with the lever in
position (2). Reduce suction power for small carpets.
Wooden floors: Use the parquet nozzle to avoid scratching.
Upholstered furniture: Use the wide crevice or the combination
nozzle/brush (3).
Curtains, lightweight fabrics, etc.: Use the combination
nozzle/brush (3). Reduce suction power if necessary.
Frames, bookshelves, etc.: Use the combination nozzle/brush
(4) or the feather duster (5).
Crevices, corners, etc.: Use the crevice nozzle (6).

Using the power nozzle

7 Attach the nozzle to the tube.
8 Use the flex supplied to connect the power nozzle to the
socket on the vacuum cleaner.
9 Use the clips to secure the cable along the tubes and
hose.
10 The power nozzle starts operating when the vacuum
cleaner is switched on.

Using the turbo nozzle

11 Attach the nozzle to the tube.
12 Adjust suction power by opening and closing the air vent.
Note! Do not use the power or turbo nozzle on skin rugs, rugs with
long fringes or rugs with a pile depth exceeding 15 mm.To avoid
damaging the carpet, do not keep the nozzle stationary whilst the
brush is rotating. Do not pass the nozzle across electric cables, and be
sure to switch off the nozzle immediately after use.