Detergent/Softener Case; Washing Machine Body/Panel; Cleaning The Tub - Toshiba AEW-9770S Owner's Manual

Remove the case to clean it. In addition, wipe away any dirt from the water supply port.
Removing the case
1
Removal procedure;
Pull the detergent /softener case toward you, then lift it for
removal.
2
Remove the cap of the detergent/softener case. Make sure
to put back the cap after removing the cap. If the washing
machine operates without the cap in place, the softener
does not enter.
Before performing any maintenance on your washing machine, be sure to remove the electrical plug from its power source.
The main body and control panel may be cleaned by wiping with a soft cloth soaked in water.
(Hard-to-remove dirt may be cleaned by wiping with a soft cloth soaked in a mind detergent.)
Caution: Never clean the body or control panel with benzine, thinner, cleanser, or other chemical cleaners. Use of such
chemicals can discolor or damage parts.
"TUB CLEANING" course
The dirt from clothes or waste water on the wash/spin basket
will cause the smell or the problem of water draining. Such
dirt from the washing process will then make the laundry dirty.
If you are in such case, please use "Tub Cleaning" program
once a month. Or in case the clothes have been starched,
please use the "Tub Cleaning" program to remove the dirt of
the starch from the basket.
"Tub Cleaning" Process
Water intake/Stir ( 1)
Soak
Wash
Drain/Spin ( 2)
Water intake/Stir ( 1)
Rinse
Drain/Spin ( 2)
1 The pulsator spins while the water level increases gradu-
ally. For the tub water, the operation may slightly differ.
2 The water spins while draining out.
•
Do not use "Tub Cleaning" program continuously.
• If there is a great amount of dirt inside the basket, you had better use the chlorine-type basket cleaner for the washing
machine. Please follow the instruction labeled on the cleaner bag.
MAINTENANCE

Detergent/Softener case

Cap
Washing machine body and panel

Cleaning the tub

about 11 min
about 20 min
about 3 min
about 3 min
about 11 min
about 3 min
about 3 min
15
Remounting procedure
1
Mount the cap of the insertion case
2
Lift the case obliquely in the same way as you remove it,
and insert it deeply along the guides.
Guides
• Normally use soap powder.
•
The amount of detergent must be more than the guided
Standard Detergent Amount.
1
Turn the POWER on.
2
Press the button and select TUB CLEANING.
3
Press the button.
•
No indicator. All indicator will light off.
4
When the pulsator (spinning board) starts to spin, add
the chlorine-type whitening detergent about 300 ml.
to the basket.
• Add it at the first used water.
•
Do not put any clothes in the basket during the "Tub
Cleaning" program.
5
Close the lid.
•
If the lid is opened during the operation, the operation
will stop before the draining and rinsing process.
Finish "Tub Cleaning" process.
• Beeping when the operation is finished.
Clean the tub.