Removing The Automatic Cartridge Adjust Linkage - HP 200 Service Manual

Removing the Automatic Cartridge Adjust Linkage

1 Remove the window D page 6 15.
2 Remove the center cover D page 6 16.
3 Remove the left endcover D page 6 18.
5 Remove the two shoulder screws that
attach the automatic cartridge adjust
linkage to the left sideplate and lift the
linkage clear of the plotter.
Torx-15
6 20 Removal and Replacement
4 Detach the linkage spring from the
Y tensioner bracket.
Reassembling: Attach the spr ng through
the two small holes, as n the d agram.
C A U T I O N
Reassembling: Do not cross thread or
over tighten the screws.
Reassembling: Rest the bottom arm of the
l nkage on top of the stepper motor shaft.
Bottom arm
of linkage
Stepper-motor
shaft
C3187 90000