Alert List - Yamaha EXi8 Owner's Manual

Alert list

Flashing [SIGNAL]
indicator
(alert number)
1 The device has not started up correctly.
The current preset saved in internal
2
memory has been lost.
The word clock master has become
3
unlocked.
There is a problem with the connection
4
of the [YDIF IN] connector.
Duplicate IP addresses.
IP address was not set within 60 sec-
5 onds of startup.
Too many devices are connected to the
network.
The UNIT ID is set to "00."
6
Devices with identical UNIT IDs were
found connected within the same net-
work.
Meaning
Turn the power off, then turn on after waiting at least 6 seconds. If this
does not solve the problem, please initialize the memory. Should this
also fails, contact your Yamaha dealer.
Recall the preset. If this does not solve the problem, contact your
Yamaha dealer.
Make sure that the word clock signal is being input correctly.
Make sure that YDIF cables are properly connected.
Use cables that meet the required specifications.
Change the IP addresses or UNIT ID so that there are no duplicates.
Please check rear panel DIP switch 6 (IP SETTING). If DIP switch 6 is
set to "PC," use the system's dedicated application software or the
DHCP server to specify the device IP address.
Reduce the number of devices connected to the network.
Set the UNIT ID to something other than "00."
Change the UNIT ID so that there are no duplicates.
Response
EXi8/EXo8 Owner's Manual
13