Key; Model; Modem [Xxxx, None]; Owm [Xxx - GE MDS 4710A Technical Manual

TX Key
Model Number Code
Analog/Digital
Modem Selection
Owner's Message
Owner's Name
Push-to-Talk Delay
TX RF Power
Output Level
28

KEY

This command activates the transmitter. See also the

MODEL

This command displays the radio's model number code.

MODEM [xxxx, NONE]

This command selects the radio's modem characteristics. For digital
operation, enter (MDS x710A) or
9600
operation, enter
NONE
When the is set to
MODEM
DATA INTERFACE
puts of the
external modem. These levels must match the audio signal level require-
ments of the external modem.
and "TXLEVEL [–20 to +6, AUTO]"
these levels.

OWM [XXX...]

Use this command to display or program an owner's message. To pro-
gram the owner's message, type
.
ENTER
To display the owner's message, type
message appears on the display.

OWN [XXX...]

Use this command to display or program an owner's name. To program
the owner's name, type
To display the owner's name, type
name appears on the display.
PTT [0–255]
Use this command to display or program the key-up delay in millisec-
onds.
This timer specifies how long to wait after the radio receives a key signal
from either the PTT or RTS lines (on the
ally keying the radio.
PWR [20–37]
NOTE: This function might not be available, depending on certifica-
tion requirements in a particular country.
MDS 4710/9710 Technical Manual
19200
.
, the analog TX Input and RX Audio out-
NONE
are used to interface with the connected
See "RXLEVEL [–20 to +6]" on Page 30
on Page 32 for details on setting
then the message, followed by
OWM
OWM
then the name, followed by
OWN
then
OWN
DATA INTERFACE
command.
DKEY
(MDS x710C). For analog
then . The owner's
ENTER
.
ENTER
. The owner's
ENTER
), before actu-
MDS 05-3305A01, Rev. E