Eternus Dx Disk Storage System Monitoring Setup; Event Notification Setup - Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions

Chapter 5 Setup

5.2 ETERNUS DX Disk Storage System Monitoring Setup

6
Click the [Done] button.
The screen display returns to the [Connectivity] screen.
This ends the basic settings. If further setup is necessary, refer to "ETERNUS Web GUI User's Guide".
5.2 ETERNUS DX Disk Storage System Monitoring Setup
Perform the ETERNUS DX Disk storage system monitoring setup if required.
For details on the setting procedures, refer to "ETERNUS Web GUI User's Guide".
This section explains the procedure for the ETERNUS DX Disk storage system monitoring setup using ETERNUS
Web GUI. For the ETERNUS DX Disk storage system monitoring setup using ETERNUS CLI, refer to "ETERNUS CLI
User's Guide".
5.2.1

Event Notification Setup

Select whether to report events detected in the ETERNUS DX Disk storage system. There are six methods for
event notification: Host Sense Key Code Qualifier, SNMP Trap, E-Mail, syslog, REMCS, and AIS Connect.
The events are classified into three levels: "Error Severity Level", "Warning Level", and "Informational Level".
Event notification contents can be specified for each event level.
The event notification setting is explained below.
Procedure
1
Start ETERNUS Web GUI.
2
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
3
In [Category], click [Event/Dump].
The [Event/Dump] screen appears.
4
In [Action], click [Setup Event Notification].
The [Setting based on Severity] tab screen of the [Setup Event Notification] screen appears.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
118
Copyright 2013 FUJITSU LIMITED
End of procedure
P3AM-4832-07ENZ0