26
Table 2-2
provides details on the LED functions for Remotes and AP
radios.
Table 2-2. Transceiver LED Functions
LED Label
LAN/ETH
COM1
(MGT System)
COM2
PWR
LINK (AP)
LINK (Remote)
2.3.1 Verify Connectivity (PING command)
If the radio LEDs indicate that the radio network is operating properly,
you can use the
PING
between the AP and an endpoint device connected to the Remote radio.
Figure 2-7
shows the typical arrangement for this test.
NOTE: To conduct a
connected to the Remote, and it must have a compatible IP
address. Remote radios do not have an IP address and cannot
be verified directly using this method.
(to test connectivity between an AP and an Ethernet endpoint)
MDS entraNET Technical Manual
Activity
Indication
ON
LAN or endpoint detected
Blinking
Data TX or RX
OFF
LAN or endpoint not detected
Blinking
Data TX or RX
OFF
No data activity
Blinking
Data TX or RX
OFF
No data activity
ON
Primary power (DC) present
Blinking
Radio in "Alarmed" state
OFF
Primary power (DC) absent
ON
Lights when radio has finished
its startup cycle. Remains lit.
ON
Connected to an AP
OFF
Not connected to an AP
command from the AP to verify the link integrity
test, an Ethernet-enabled device must be
PING
Figure 2-7. PING Test Setup
05-4055A01, Rev. E