Troubleshooting Chart; Enhancing Your System - Sharp CD-G14000 Operation Manual

CD-G14000
Enhancing your system (continued)
CD-G17000
CD-G22000
ENGLISH
Headphones
Before plugging in or unplugging the headphones, reduce the
volume.
Be sure your headphones have a 3.5 mm (1/8") diameter plug
and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging in the
automatically. Adjust the volume using the VOLUME control.
Do not turn the volume on to full at switch on. Listen to music at
moderate levels. Excessive sound pressure from earphones and
headphones can cause hearing loss.
E-42
headphones disconnects the
5
4
3
2
1
TIMER
POWER
ON/ STAND-BY
CD
TAPE
(1 2)
TUNER
(BAND)
PRESET PRESET
AUDIO
IN
TUNING TUNING
VOL. VOL.
PLAYBACK (PLAY & STOP) RECORD/PLAYBACK
AUDIO
PHONES IN

Troubleshooting chart

Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
speakers
Symptom
The clock is not set to the
correct time.
When a button is pressed,
the unit does not respond.
No sound is heard.
REMOTE
SENSOR
OPEN/
c
CLOSE
5
4
3
2
1
CD player
Symptom
Playback does not start.
Playback stops in the
middle or is not performed
properly.
Playback sounds are
skipped, or stopped in the
middle of a track.
Possible cause
Did a power failure occur? Reset
the clock. (Refer to pages 19 - 20.)
Set the unit to the power stand-by
mode and then turn it back on.
If the unit still malfunctions, reset
it. (Refer to page 44.)
Is the volume level set to "0"?
Are the headphones connected?
Are the speaker wires
disconnected?
Possible cause
Is the disc loaded upside down?
Does the disc satisfy the
standards?
Is the disc distorted or
scratched?
Is the unit located near excessive
vibrations?
Is the disc very dirty?
Has condensation formed inside
the unit?