How To Connect The Pc Input Terminals - Panasonic TU-PTA500U Operating Instructions Manual

Installation

How to connect the PC Input Terminals

Computer
Notes:
(1) Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical
scanning frequency of 48 to 120 Hz. (However, signals exceeding 1200 lines will not be displayed properly.)
(2) The display resolution is a maximum of 640
dots when the aspect mode is set to "FULL". If the display resolution exceeds these maximums, it may not be
possible to show fine detail with sufficient clarity.
(3) Some PC models cannot be connected to the set.
(4) An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.
(5) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
(6) The computer shown in the illustration is for example purposes only.
(7) Additional equipment and cables shown are not supplied with this set.
(8) Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
Signal Names for D-sub 15P Connector
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
Pin layout for PC input
terminal
14
Conversion adapter (if necessary)
Connect a cable which matches the
audio output terminal on the computer.
480 dots when the aspect mode is set to "NORMAL", and 852
Pin No. Signal Name
1 R
2 G
3 B
4 GND (Ground)
5 GND (Ground)
POWER R-STAND BY
G-POWER ON
MENU ACTION INPUT VOLUME CHANNEL
RGB
PC cable
Pin No. Signal Name
6 GND (Ground)
7 GND (Ground)
8 GND (Ground)
9 NC (not connected)
10 GND (Ground)
INPUT 3
S-VIDEO VIDEO L-AUDIO-R
PC-IN
D-sub 15p
1/8" (3 mm) stereo plug
Pin No. Signal Name
11 GND (Ground)
12 NC
13 HD / SYNC
14 VD
15 NC
480