Advertisement
D9131A
Overview
Text
Usually this is programmed by your alarm technician, however, the following text is not:
SDI XX- Event reported was initiated by the Serial Device Interface indicated. The numbers 1 through 8 indicate the
event is from one of the supervised command centers. The numbers 17, 18 or 19 indicate the event is from a printer.
Numbers 33 to 40 indicate the event is from the Access Control Module.
(The following text indicates previous armed status.)
Was Master Armed
Was Perim Delay
Was Perim Instant
Was Disarmed
Was Mstr Instnt
User Text
Your alarm technician usually will program this. User text is printed whenever an event with a User ID is noted.
34584G
D9131A User's Guide
Page 4
© 2002 Bosch Security Systems
Advertisement
